Transient Fluid Flow during Steady Continuous Casting of Steel Slabs: Part I. Measurements and Modeling of Two-phase Flow

Unstable mold flow could induce surface velocity and level fluctuations, and entrain slag, leading to surface defects during continuous casting of steel. Both argon gas injection and Electro-Magnetic Braking (EMBr) greatly affect transient mold flow and stability. Part I of this two-part article investigates transient flow of steel and argon in the nozzle and mold during nominally steady-state casting using both plant measurements and computational modeling. Nail board dipping measurements are employed to quantify transient surface level, surface velocity, flow direction, and slag depth. Transient flow in the nozzle and strand is modeled using Large Eddy Simulation (LES) coupled with the Lagrangian Discrete Phase Model (DPM) for argon gas injection. The surface level of the molten steel fluctuates due to sloshing and shows greater fluctuations near the nozzle. The slag level fluctuates with time according to the lifting force of the molten steel motion below. Surface flow shows a classic double roll pattern with transient cross-flow between the Inside Radius (IR) and the Outside Radius (OR), and varies with fluctuations up to similar to 50% of the average velocity magnitude. The LES results suggest that these transient phenomena at the surface are induced by up-and-down jet wobbling caused by transient swirl in the slide-gate nozzle. The jet wobbling influences transient argon gas distribution and the location of jet impingement on the Narrow Face (NF), resulting in variations of surface level and velocity. A power-spectrum analysis of the predicted jet velocity revealed strong peaks at several characteristic frequencies from 0.5-2 Hz (0.5-2 sec).