Highly-conductive proton-conducting electrolyte membranes with a low sintering temperature for solid oxide fuel cells

The microwave sintering strategy was for the first time adopted to prepare proton-conducting electrolyte membranes for solid oxide fuel cells. The preparation of a dense proton-conducting BaCe0.7Zr0.1Y0.2O3-delta (BCZY) electrolyte membrane can be achieved at 1200 degrees C with the microwave sintering method. In sharp contrast, a BCZY sample prepared at 1200 degrees C using the conventional thermal sintering method was found to be porous. In comparison with a dense BCZY sample prepared at 1400 degrees C using the conventional sintering method, the microwave-sintered BCZY electrolyte showed an improved proton conductivity, which is beneficial for fuel cell applications. Experimental results showed that the microwave sintering method enabled a homogenous elemental distribution and a suppression of barium evaporation, leading to the conductivity improvement in both bulk and grain boundaries. With the microwave sintered BCZY film as the electrolyte, a proton-conducting solid oxide fuel cell delivered a maximum power density of 838 mW cm(-2) at 700 degrees C with an electrolyte film conductivity as high as 1.4 x 10(-2) S cm(-1). This study suggests that the microwave sintering method is a promising strategy to prepare electrolyte membranes at a relatively low temperature with high conductivity, which could advance the development of proton-conducting solid oxide fuel cells.