A mechanistic model for breakage in population balances of granulation: Theoretical kernel development and experimental validation

被引:66
|
作者
Ramachandran, Rohit [1 ]
Immanuel, Charles D. [1 ]
Stepanek, Frantisek [1 ]
Litster, James D. [2 ]
Doyle, Francis J., III [3 ]
机构
[1] Univ London Imperial Coll Sci Technol & Med, Dept Chem Engn, Ctr Proc Syst Engn, London SW7 2AZ, England
[2] Purdue Univ, Sch Chem Engn, W Lafayette, IN 47907 USA
[3] Univ Calif Santa Barbara, Dept Chem Engn, Santa Barbara, CA 93106 USA
来源
基金
英国工程与自然科学研究理事会;
关键词
Granulation; High-shear mixing; Multi-dimensional population balance; Breakage; Mechanistic kernels; Experimental validation; BED MELT GRANULATION; HIGH-SHEAR MIXER; KINETICS; AGGREGATION; NUCLEATION; GROWTH; ENERGY;
D O I
10.1016/j.cherd.2008.11.007
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
in this study, a dynamic model is presented for the granulation process, employing a three-dimensional population balance framework. The major focus of this work is the theoretical development and experimental validation of a novel mechanistic breakage kernel that is incorporated within the population balance equation. Qualitative validation of breakage kernel/model was first performed and trends of lumped properties (i.e., total particles, average size, binder content and porosity) and distributed properties (i.e., granule size and fractional binder content) show good agreement with the expected phenomenological behaviour. Successful high-shear mixer granulation experiments using glass-ballotini as the primary powder and poly-vinyl alcohol in water (PVOH-H2O) as the liquid binder were then carried out to mimic predominantly breakage-only behaviour whereby the rate of breakage was greater than the rates of nucleation and aggregation. Good agreement between experimental and simulation results were obtained for the granule size distribution under different operating conditions. In addition, accurate model predictions were obtained for the evolution of the lumped properties. (C) 2008 Published by Elsevier B.V. on behalf of The Institution of Chemical Engineers.
引用
收藏
页码:598 / 614
页数:17
相关论文
共 50 条
  • [31] Development and experimental validation of a mechanistic model of cutting forces in micro- ball end milling of full slots
    Baburaj, M.
    Ghosh, A.
    Shunmugam, M. S.
    MACHINING SCIENCE AND TECHNOLOGY, 2018, 22 (05) : 787 - 810
  • [32] Development and validation of an experimental and theoretical method for the chiral discrimination of dinotefuran
    Silva, Camilla Fonseca
    Guimaraes, Luciana
    Borges, Keyller Bastos
    Nascimento, Clebio Soares, Jr.
    CHIRALITY, 2020, 32 (01) : 53 - 63
  • [33] DEVELOPMENT AND VALIDATION OF A THEORETICAL MATHEMATICAL-MODEL OF THE PERIODONTIUM
    TOPKAYA, A
    SCHOLZ, F
    SCHULTE, W
    DEUTSCHE ZAHNARZTLICHE ZEITSCHRIFT, 1986, 41 (06): : 635 - 639
  • [34] Theoretical development and validation of a fatigue model for ship routing
    Mao, Wengang
    Ringsberg, Jonas W.
    Rychlik, Igor
    Li, Zhiyuan
    SHIPS AND OFFSHORE STRUCTURES, 2012, 7 (04) : 399 - 415
  • [35] Development and validation of a theoretical model for cognitive skills acquisition
    Tang, KH
    Koubek, RJ
    Lightner, NJ
    Salvendy, G
    INTERNATIONAL JOURNAL OF INDUSTRIAL ERGONOMICS, 1999, 24 (01) : 25 - 38
  • [36] Development and validation of a theoretical model for diesel spray penetration
    Desantes, JM
    Payri, R
    Salvador, FJ
    Gil, A
    FUEL, 2006, 85 (7-8) : 910 - 917
  • [37] Development and experimental validation of a compressor dynamic model
    Venturini, M
    JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 2005, 127 (03): : 599 - 608
  • [38] Numerical and experimental validation of a theoretical model for bimaterial helical springs
    Dragoni, Eugenio
    Bagaria, William J.
    JOURNAL OF STRAIN ANALYSIS FOR ENGINEERING DESIGN, 2013, 48 (03): : 166 - 176
  • [39] RESISTANCE HEATING OF OXIDE SLAGS - THEORETICAL MODEL AND EXPERIMENTAL VALIDATION
    Kranti, R.
    Kumar, M.
    Ranganathan, S.
    Saxena, S. B. Lal
    Mehrotra, S. P.
    CANADIAN METALLURGICAL QUARTERLY, 2009, 48 (04) : 387 - 397
  • [40] The theoretical model of broad band dye laser and experimental validation
    Wang Mo-Ge
    Lu Qi-Sheng
    Xu Xiao-Jun
    Guo Shao-Feng
    ACTA PHYSICA SINICA, 2008, 57 (03) : 1857 - 1861