Synthesis and Characteristics of Zn-Doped CuCrO2 Transparent Conductive Thin Films

被引:6
|
作者
Yu, Ruei-Sung [1 ,2 ]
Chu, Chen [1 ]
机构
[1] Asia Univ, Dept Photon & Commun Engn, 500 Lioufeng Rd, Taichung 41354, Taiwan
[2] China Med Univ, China Med Univ Hosp, Dept Med Res, Taichung 40402, Taiwan
来源
COATINGS | 2019年 / 9卷 / 05期
关键词
CuCrO2; zinc-doped; thin film; structure; optoelectronic properties; PULSED-LASER DEPOSITION; P-N-JUNCTIONS; FABRICATION;
D O I
10.3390/coatings9050321
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The effects of doping a p-type CuCrO2 film with zinc on its structural and optoelectronic properties were investigated by experiments using CuCr1-xZnxO2 thin films (x = 0, 0.025, 0.065, 0.085). An increase in the amount of zinc dopant in the thin films affected the lattice constant and increased its Gibbs free energy of phase transformation. Cross-sectional images of the CuCrO2 thin film samples exhibited a dense polygonal microstructure and a surface morphology with protruding nanoscale granules. With the increase in the amount of Zn dopant, the surface roughness decreased, thereby increasing the amount of incident photons as well as the visible-light transmittance and ultraviolet-light absorption of the thin films. With the zinc doping in the CuCrO2 thin films, the band gap increased from 3.09 to 3.11 eV. The substitution of Cr3+ with Zn2+ forms hole carriers in the crystals, which was demonstrated by X-ray photoelectron spectroscopy and Hall effect measurements. The conductivities and carrier concentrations of the Zn-doped CuCrO2 thin films were greater than those of undoped CuCrO2. The CuCr1-xZnxO2 film (x = 0.065) exhibited the best optoelectronic properties; its carrier concentration and resistivity were 1.88 x 10(17) cm(-3) and 3.82 Omega cm, respectively.
引用
收藏
页数:11
相关论文
共 50 条
  • [1] Characteristics of p-type transparent conductive CuCrO2 thin films
    Yu, Ruei-Sung
    Wu, Chung-Ming
    APPLIED SURFACE SCIENCE, 2013, 282 : 92 - 97
  • [2] Transparent p-type Zn-doped CuCrO2 films by sol-gel processing
    Chen, Hong-Ying
    Yang, Chun-Chao
    SURFACE & COATINGS TECHNOLOGY, 2013, 231 : 277 - 280
  • [3] Development of a fast annealing process to prepare transparent conductive Mg-doped CuCrO2 thin films
    Chen, Hong-Ying
    Wu, Jun-Ting
    Huang, Chi
    THIN SOLID FILMS, 2016, 605 : 180 - 185
  • [4] Review in optoelectronic properties of p-type CuCrO2 transparent conductive films
    Bai, Zhamatuofu
    Chen, Sheng-Chi
    Lin, Song-Sheng
    Shi, Qian
    Lu, Ying-Bo
    Song, Shu-Mei
    Sun, Hui
    SURFACES AND INTERFACES, 2021, 22
  • [5] Atomic layer deposition of transparent semiconducting oxide CuCrO2 thin films
    Tripathi, T. S.
    Niemela, Janne-Petteri
    Karppinen, Maarit
    JOURNAL OF MATERIALS CHEMISTRY C, 2015, 3 (32) : 8364 - 8371
  • [6] Dry etching of CuCrO2 thin films
    Lim, W. T.
    Sadik, P. W.
    Norton, D. P.
    Pearton, S. J.
    Ren, F.
    APPLIED SURFACE SCIENCE, 2008, 254 (08) : 2359 - 2363
  • [7] p-Type conducting transparent characteristics of delafossite Mg-doped CuCrO2 thin films prepared by RF-sputtering
    Barnabe, A.
    Thimont, Y.
    Lalanne, M.
    Presmanes, L.
    Tailhades, P.
    JOURNAL OF MATERIALS CHEMISTRY C, 2015, 3 (23) : 6012 - 6024
  • [8] Highly Conductive and Visibly Transparent p-Type CuCrO2 Films by Ultrasonic Spray Pyrolysis
    Kim, Jaewon
    Kendall, Owen
    Ren, Jiawen
    Murdoch, Billy J.
    McConville, Christopher F.
    van Embden, Joel
    Della Gaspera, Enrico
    ACS APPLIED MATERIALS & INTERFACES, 2022, 14 (09) : 11768 - 11778
  • [9] Zn-doped CuAlS2 transparent p-type conductive thin films deposited by pulsed plasma deposition
    Yang, Ming
    Wang, Yinghua
    Li, Guifeng
    Shi, Zhan
    Zhang, Qun
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2009, 27 (06): : 1316 - 1319
  • [10] Microstructural and Electrical Characteristics of Preferential Growth Direction Controlled CuCrO2 Thin Films
    Kim, Se-Yun
    Jo, Kwang-Min
    Lee, Joon-Hyung
    Kim, Jeong-Joo
    Heo, Young-Woo
    JOURNAL OF NANOELECTRONICS AND OPTOELECTRONICS, 2013, 8 (06) : 579 - 583