On the use of body biasing to improve linearity in low LO-power CMOS active mixers

In a radio-frequency (RF) transceiver, the linearity of the mixer has a profound effect on the overall transceiver performance. In many RF transceivers, active mixers are used due to their higher gain which also improves the overall receiver noise figure. In a typical RF active mixer where the transistors in the LO stage switch abruptly, most of the nonlinear distortions come from the transconductance or RF stage and thus the linearity of the mixer can be enhanced by proper design of the RF stage. In low-power receivers, however, to reduce the power consumption of the local oscillator (LO) circuit, the amplitude of LO signal is low and thus the switching of the transistors in the LO stage of the mixer is gradual. In this paper, we propose a technique to improve the linearity of such low-power mixers by enhancing the linearity of the LO stage. In particular, body biasing is utilized in the LO stage to improve the linearity. To verify the effectiveness of the proposed technique, two proof-of-concept double-balanced down-conversion active mixers have been designed and fabricated in 0.13-mu m CMOS. The maximum IIP3 of +2.7 dBm and -4.9 dBm at a conversion gain of 13 dB and 16 dB are achieved for the first and second prototype respectively. For a 2.4 GHz RF input signal and an intermediate-Frequency (IF) of 50 MHz, the first prototype consumes 2.4 mW from a 1.2 V supply while the second one consumes only 780 mu W from a 0.7 V supply. (C) 2014 Elsevier Ltd. All rights reserved.