Development of pyroelectric ceramics for high-temperature applications

被引：6

作者：

Barrel, Jeremie ^{[1
,2
]}

MacKenzie, Kenneth J. D. ^{[1
]}

Stytsenko, Eugene ^{[2
]}

Viviani, Massimo ^{[3
]}

机构：

[1] Victoria Univ Wellington, MacDiarmid Inst Adv Mat & Nanotechnol, Wellington, New Zealand

[2] Ind Res Ltd, Lower Hutt, New Zealand

[3] IENI CNR, I-16149 Genoa, Italy

来源：

MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS | 2009年 / 161卷 / 1-3期

关键词：

Doping effects; Electrical measurements; Film deposition; FILMS; COEFFICIENTS;

D O I：

10.1016/j.mseb.2009.01.007

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Ceramics based on Bi3NbTiO9 (BNT) were investigated for their high-temperature pyroelectric properties. Doping BNT with 0.05 atoms of WG+ donor ions decreased its DC conductivity, enhanced its dielectric strength and remnant polarization. Thick films of BNT produced by airflow deposition show preferential grain orientation and enhanced sinterability, giving improved polarizability and higher dielectric strength than the comparable ceramic. Further improvements in grain orientation and enhanced remnant polarization are derived by sintering under an applied electric field. Airflow deposition was also used to prepare graded films of Ba(1-x)SrxTiO3 (BST), showing temperature dependent hysteresis offsets that originate from asymmetric leakage currents and are not related to the pyroelectric properties. These graded films show an enhanced conventional pyroelectric coefficient over a wide temperature range. These results predict that a graded structure of BaBi2Ta2O9 and Bi3NbTi0.95W0.05O9 should show enhanced high-temperature pyroelectric properties. (C) 2009 Elsevier B.V. All rights reserved.

引用

页码：125 / 129

页数：5

共 50 条

[11] New approaches to joining ceramics for high-temperature applications
Locatelli, MR
Dalgleish, BJ
Nakashima, K
Tomsia, AP
Glaeser, AM
CERAMICS INTERNATIONAL, 1997, 23 (04) : 313 - 322
[12] DEVELOPMENT OF HIGH-TEMPERATURE COATINGS AND APPLICATIONS
LONG, JV
SAE TRANSACTIONS, 1969, 78 : 129 - &
[13] HIGH-TEMPERATURE CERAMICS
TYMCZAK, RW
MCMURTY, CH
SANDMEYE.KH
INDUSTRIAL RESEARCH, 1971, 13 (13): : 53 - &
[14] LOW-TEMPERATURE ROUTES TO JOINING CERAMICS FOR HIGH-TEMPERATURE APPLICATIONS
DALGLEISH, BJ
TOMSIA, AP
NAKASHIMA, K
LOCATELLI, MR
GLAESER, AM
SCRIPTA METALLURGICA ET MATERIALIA, 1994, 31 (08): : 1043 - 1048
[15] Development of high-temperature corrosion resistant equipment with ceramics
Takegami, Hiroaki
Noguchi, Hiroki
Terada, Atsuhiko
JOURNAL OF THE ATOMIC ENERGY SOCIETY OF JAPAN, 2007, 49 (10): : 693 - 697
[16] Joining of sintered silicon carbide ceramics for high-temperature applications
NYMA, Inc, Cleveland, United States
J Mater Sci Lett, 6 (459-461):
[17] SHS of Silicon-Based Ceramics for the High-Temperature Applications
Vorotilo, Stepan
Potanin, Artem Y.
Iatsyuk, Ivan V.
Levashov, Evgeny A.
ADVANCED ENGINEERING MATERIALS, 2018, 20 (08)
[18] BASIC RESEARCH NEEDS ON HIGH-TEMPERATURE CERAMICS FOR ENERGY APPLICATIONS
BOWEN, HK
MATERIALS SCIENCE AND ENGINEERING, 1980, 44 (01): : 1 - 56
[19] Joining of sintered silicon carbide ceramics for high-temperature applications
Singh, M
JOURNAL OF MATERIALS SCIENCE LETTERS, 1998, 17 (06) : 459 - 461
[20] STRONTIUM-BASED ELECTRONIC CERAMICS FOR HIGH-TEMPERATURE APPLICATIONS
GRAY, TJ
CASTELLIZ, KM
ROUTIL, RJ
ROCKWELL, M
JOURNAL OF SOLID STATE CHEMISTRY, 1975, 12 (3-4) : 330 - 330

← 1 2 3 4 5 →