Influence of Mn Addition on Fatigue Limit and Coaxing Effect in Ferritic Steel Containing Solute Carbon

被引：2
|
作者：
Uchida, Yusui [1 ]
Koyama, Motomichi [2 ]
Fukushima, Yoshihiro [1 ]
Tsuzaki, Kaneaki [1 ,2 ,3 ,4 ]
机构：
[1] Kyushu Univ, Dept Mech Engn, Nishi Ku, Motooka 744, Fukuoka 8190395, Japan
[2] Tohoku Univ, Inst Mat Res, Aoba Ku, Katahira 2-1-1, Sendai, Miyagi 9808577, Japan
[3] Kyushu Univ, Sengen 1-2-1, Tsukuba, Ibaraki 3050047, Japan
[4] Natl Inst Mat Sci, Res Ctr Struct Mat, Sengen 1-2-1, Tsukuba, Ibaraki 3050047, Japan
来源：
ISIJ INTERNATIONAL | 2022年 / 62卷 / 10期
关键词：
fatigue limit; coaxing effect; fatigue crack initiation; non-propagating fatigue crack; solute carbon; CRACK PROPAGATION; INTRINSIC-FACTORS; BEHAVIOR; INITIATION; MANGANESE; TRIGGER; ALLOYS; ATOMS; FOCUS;
D O I：
10.2355/isijinternational.ISIJINT-2021-562
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
The influence of Mn addition on fatigue properties of ferritic steel containing solute carbon was examined using rotating bending fatigue tests on water-quenched Fe-0.016C-1.9Mn ferrite-pearlite steel containing 0.0035 mass% solute carbon in comparison with water-quenched Fe-C ferritic steels containing 0.0063-0.017 mass% solute carbon. The fatigue tests were carried out at ambient temperature around 300 K and a frequency of 50 Hz with a stress ratio of - 1. The Fe-C-Mn steel exhibited a comparable hardness and fatigue limit to the water-quenched Fe-0.017C steel which contains about three times the amount of solute carbon than the Fe-C-Mn steel. In addition, the Fe-C-Mn steel exhibited a significant coaxing effect in comparison to the Fe-C steels, when the test was started from a stress amplitude just below the fatigue limit. Crack initiation sites were changed by stress amplitude unlike in the Fe-C steels. Specifically, intergranular cracks were observed at the high stress amplitudes and transgranular cracks were observed at the low stress amplitudes near the fatigue limit. It was concluded that the Mn addition suppresses intergranular cracking at the low stress amplitudes.
引用
收藏
页码：2135 / 2146
页数：12
相关论文
共 50 条
  • [41] Effect of strengthening mechanisms on fatigue limit for slip bands formation of low carbon sheet steel
    Kurita, M
    Yamamoto, M
    Kunishige, K
    FATIGUE '99: PROCEEDINGS OF THE SEVENTH INTERNATIONAL FATIGUE CONGRESS, VOLS 1-4, 1999, : 585 - 590
  • [42] Influence of temperature on a low-cycle fatigue behavior of a ferritic stainless steel
    S. M. Humayun Kabir
    Tae-in Yeo
    Journal of Mechanical Science and Technology, 2014, 28 : 2595 - 2607
  • [43] Effect of shot peening coverage on fatigue limit in round bar of annealed medium carbon steel
    Junji Sakamoto
    Yong-Sung Lee
    Seong-Kyun Cheong
    Journal of Mechanical Science and Technology, 2014, 28 : 3555 - 3560
  • [44] High-Strength Low-Carbon Ferritic Steel Containing Cu-Fe-Ni-Al-Mn Precipitates
    Semyon Vaynman
    Dieter Isheim
    R. Prakash Kolli
    Shrikant P. Bhat
    David N. Seidman
    Morris E. Fine
    Metallurgical and Materials Transactions A, 2008, 39 : 363 - 373
  • [45] High-strength low-carbon ferritic steel containing Cu-Fe-Ni-Al-Mn precipitates
    Vaynman, Semyon
    Isheim, Dieter
    Kolli, R. Prakash
    Bhat, Shrikant P.
    Seidman, David N.
    Fine, Morris E.
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2008, 39A (02): : 363 - 373
  • [46] Improvement fatigue limit of steel containing a small crack-like surface defect by overload effect
    Mizukami, Hiroshi
    Hanaori, Kazuya
    Takahashi, Koji
    Tange, Akira
    Ando, Kotoji
    INTERNATIONAL JOURNAL OF STRUCTURAL INTEGRITY, 2010, 1 (02) : 153 - 160
  • [47] Effect of hot forging and Mn content on austenitic stainless steel containing high carbon
    Farahat, Ahmed Ismail Zaky
    Hamed, Osama
    El-Sisi, Ahmed
    Hawash, Mohamed
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 530 : 98 - 106
  • [48] Effect of Aluminum Addition with Nitrogen on K-Carbide Formation in Carbon-Mn Steel
    Abro, Shahid Hussain
    Chandio, Alidad
    Shaikh, Asif Ahmed
    Nordin, Norbaizura
    MATERIALS SCIENCE-MEDZIAGOTYRA, 2022, 28 (01): : 48 - 52
  • [49] The influence of HAZ on fatigue life of 16Mn steel
    Chen, G.
    Luo, X. M.
    Chen, X.
    Zhang, W. H.
    MATERIALS AND PRODUCT TECHNOLOGIES, 2008, 44-46 : 323 - +
  • [50] INFLUENCE OF THE MAGNETOMECHANICAL EFFECT IN TESTING OF INDUCTIVELY HEATED FERRITIC STEEL
    JONES, WB
    SCRIPTA METALLURGICA, 1982, 16 (09): : 1067 - 1072
12345