On heat and moisture transfer characteristics of a desiccant dehumidification unit using fin tube heat exchanger with silica gel coating

被引：44

作者：

Zhao, Y. ^{[1
]}

Dai, Y. J. ^{[1
]}

Ge, T. S. ^{[1
]}

Sun, X. Y. ^{[1
]}

Wang, R. Z. ^{[1
]}

机构：

[1] Shanghai Jiao Tong Univ, Inst Refrigerat & Cryogen, Shanghai Engn Res Ctr Solar Power & Refrigerat, MOE China, Shanghai 200240, Peoples R China

来源：

APPLIED THERMAL ENGINEERING | 2015年 / 91卷

关键词：

Desiccant dehumidification; Heat transfer; Moisture transfer; Silica gel coating; Fitted calculation; PERFORMANCE; SYSTEM; COILS;

D O I：

10.1016/j.applthermaleng.2015.07.075

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

In this paper, the heat and moisture transfer characteristics of a desiccant dehumidification unit using fin-tube heat exchanger with silica gel coating have been experimentally investigated. The present study focuses on the analysis of air side heat and moisture transfer performance in dehumidification mode. The empirical formula on Nusselt and Sherwood numbers were deducted and curve fitted from the test results under various operation conditions, using the non-linear least square method. The typical operation condition is that the air side Reynolds number ranges between 220 and 550 and tube side cooling water flow rate is about 7.7 L/min. Further tests indicate that the correlations of Nusselt and Sherwood number on air side of the unit agree well with the test results, and the mean errors are about +/- 10% and +/- 12%, respectively. Finally, the improvements of the operation and configuration parameters of this novel heat and moisture transfer components are discussed with those formulas. It is found that the correlated formulas provide the theoretical basis and practical experience for design and optimization of the desiccant dehumidification unit using fin tube heat exchanger with silica gel coating. (C) 2015 Elsevier Ltd. All rights reserved.

引用

页码：308 / 317

页数：10

共 50 条

[11] Airside heat transfer and friction characteristics for enhanced fin-and-tube heat exchanger with hydrophilic coating under wet conditions
Ma, Xiaokui
Ding, Guoliang
Zhang, Yuanming
Wang, Kaijian
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2007, 30 (07): : 1153 - 1167
[12] Heat transfer enhancement for fin-tube heat exchanger using vortex generators
Seong-Yeon Yoo
Dong-Seong Park
Min-Ho Chung
Sang-Yun Lee
KSME International Journal, 2002, 16 : 109 - 115
[13] Heat transfer enhancement for fin-tube heat exchanger using vortex generators
Yoo, SY
Park, DS
Chung, MH
Lee, SY
KSME INTERNATIONAL JOURNAL, 2002, 16 (01): : 109 - 115
[14] Convective heat transfer and fluid flow characteristics in fin and oval-tube heat exchanger
Abdoune, Y.
Sahel, D.
Benzeguir, R.
Alem, K.
JOURNAL OF MECHANICAL ENGINEERING AND SCIENCES, 2021, 15 (02) : 7936 - 7947
[15] FLOW AND HEAT TRANSFER CHARACTERISTICS OF A FIN-AND-TUBE HEAT EXCHANGER WITH WAVY RIB INSERTS
Li, Li
Du, Xiaoze
Yang, Lijun
Yang, Yongping
Wei, Gaosheng
JOURNAL OF ENHANCED HEAT TRANSFER, 2016, 23 (06) : 465 - 485
[16] INVESTIGATION OF CONJUGATE HEAT TRANSFER IN A FIN-AND-TUBE HEAT EXCHANGER
Kadja, M.
Mebrouk, R.
PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, 2014, VOL 8A, 2015,
[17] Enhancement of heat transfer by a fin with two fences and tube heat exchanger
Onishi, H
Suzuki, K
Inaoka, K
HEAT TRANSFER SCIENCE AND TECHNOLOGY 2000, 2000, : 667 - 673
[18] Analysis of heat transfer in a wavy fin-and-tube heat exchanger
Wolf, I
Frankovic, B
Vilicic, I
Jurkowski, R
Bailly, A
STROJARSTVO, 2004, 46 (4-6): : 137 - 147
[19] Conjugated Heat Transfer Simulation of a Fin-and-Tube Heat Exchanger
Valikangas, Turo
Karvinen, Reijo
HEAT TRANSFER ENGINEERING, 2018, 39 (13-14) : 1192 - 1200
[20] Experimental Study on the Heat Transfer Characteristics of a Spiral Fin-Tube Heat Exchanger with Staggered Tube Alignment
Kang, Taehyung
Lee, Mooyeon
Kim, Yongchan
Yun, Sungjung
ACRA 2009: PROCEEDINGS OF THE 4TH ASIAN CONFERENCE ON REFRIGERATION AND AIR-CONDITIONING, 2009, : 199 - 203

← 1 2 3 4 5 →