Detection of the Most Suitable Method to Estimate Short-Circuit Parameter's Values of the Electric Facility

被引:0
|
作者
Akbal, Bahadir [1 ]
Urkmez, Abdullah [1 ]
机构
[1] Selcuk Univ, Dept Elect & Elect Engn, Konya, Turkey
来源
ICECCO'12: 9TH INTERNATIONAL CONFERENCE ON ELECTRONICS, COMPUTER AND COMPUTATION | 2012年
关键词
Accuracy rate; CSA; electric facility; GA; Short-circuit capacity; short circuit parameters; OPTIMAL POWER-FLOW; ALGORITHM;
D O I
暂无
中图分类号
TP18 [人工智能理论];
学科分类号
081104 ; 0812 ; 0835 ; 1405 ;
摘要
Short-circuit is a damaging event for electrical facilities and electric networks. Thus short circuit capacity of a main circuit breaker of an electrical facility must be determined correctly. Otherwise, then circuit breaker cannot cut shortcircuit current, and so protection and measuring elements are damaged. Primarily short-circuit parameter values of electric facility which will be connected to an electrical network must be determined correctly to determine short-circuit capacity of main circuit breaker of electric facility. In this study, short circuit parameter's values of electric facility were estimated by using clonal selection algorithm (CSA) and genetic algorithm (GA). The end of this study, accuracy rate of estimated short-circuit parameters with CSA and GA was compared. The best solution algorithm was determined for these problems.
引用
收藏
页码:202 / 206
页数:5
相关论文
共 50 条
  • [21] High-Impedance Transformer Parameter Determination Method for Limiting Short-Circuit Current of Power System
    Li, Yuze
    Liu, Bingchen
    Zhu, Yingwei
    Hou, Jiansheng
    Liu, Ran
    Guo, Lingqing
    2019 22ND INTERNATIONAL CONFERENCE ON ELECTRICAL MACHINES AND SYSTEMS (ICEMS 2019), 2019, : 4503 - 4507
  • [22] A METHOD FOR THE DETERMINATION OF THE MATERIAL PARAMETER-TAU, PARAMETER-D, PARAMETER-L0, PARAMETER-S AND PARAMETER-A FROM MEASURED AC SHORT-CIRCUIT PHOTOCURRENT
    GUPTA, S
    AHMED, F
    GARG, S
    SOLAR CELLS, 1988, 25 (01): : 61 - 72
  • [23] Application of Wu method in electric-magnetic transient analysis during power system short-circuit
    Chen, Chen
    Cao, Wei
    Zhongguo Dianji Gongcheng Xuebao/Proceedings of the Chinese Society of Electrical Engineering, 2002, 22 (11): : 16 - 19
  • [24] Compensation Parameter Configuration Method for Wireless Charging System With LCC-S Topology to Achieve a Lightweight Receiver and Short-circuit Tolerance
    Tian Z.
    Zhang X.
    Wang Y.
    Wu X.
    Cheng S.
    Wei B.
    Kang J.
    Zhao H.
    Zhongguo Dianji Gongcheng Xuebao/Proceedings of the Chinese Society of Electrical Engineering, 2023, 43 (18): : 7223 - 7231
  • [25] A Novel Method of Impedance Measurement Used in Islanding Detection Based on Controllable Short-circuit Technology
    Zhu, Ke
    Lu, Xiaohui
    Zhang, Bo
    MECHANICAL AND ELECTRONICS ENGINEERING III, PTS 1-5, 2012, 130-134 : 752 - 756
  • [26] A Search Coil Design Method of PMSM for Detection of Inter-Turn Short-Circuit Fault
    Li, Rui
    Fang, Haiyang
    Li, Dawei
    Qu, Ronghai
    Yang, Songbai
    Wang, Runyu
    IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, 2024, 71 (04) : 3964 - 3974
  • [27] A novel method of impedance measurement used in islanding detection based on controllable short-circuit technology
    Key Laboratory of Power System Intelligent Dispatch and Control of Ministry of Education, Shandong University, Jinan 250061, China
    不详
    Dianli Xitong Zidonghue, 2013, 2 (119-124):
  • [28] Interturn Short-Circuit Fault Detection of PMSM by High-Frequency Signal Injection Method
    Zhou, Fatang
    Cao, Wenping
    Wang, Hui
    Hu, Cungang
    PROCEEDINGS OF THE 3RD INTERNATIONAL SYMPOSIUM ON NEW ENERGY AND ELECTRICAL TECHNOLOGY, 2023, 1017 : 99 - 107
  • [29] Fast short-circuit fault detection method based on a small half-wave feature
    Wu X.
    Shi J.
    Chen H.
    Chen L.
    Chen J.
    Dianli Xitong Baohu yu Kongzhi/Power System Protection and Control, 2022, 50 (16): : 86 - 94
  • [30] Fault identification method of rotor inter turn short-circuit using stator winding detection
    Li, YG
    Li, HM
    Hua, Z
    Wan, ST
    ICEMS 2003: PROCEEDINGS OF THE SIXTH INTERNATIONAL CONFERENCE ON ELECTRICAL MACHINES AND SYSTEMS, VOLS 1 AND 2, 2003, : 856 - 860