Investigation of effect of burner diameter on heat transfer characteristics of methane/air flame impinging on a flat surface

被引：2

作者：

Chander, Subhash ^{[1
]}

Ray, Anjan ^{[1
]}

机构：

[1] Indian Inst Technol Delhi, Dept Mech Engn, New Delhi 110016, India

来源：

HT2005: PROCEEDINGS OF THE ASME SUMMER HEAT TRANSFER CONFERENCE 2005, VOL 1 | 2005年

关键词：

impingement; Heat Transfer; Premixed Flame; burner diameter; Flame Shapes;

D O I：

10.1115/HT2005-72545

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

An experimental study has been conducted to investigate the effect of burner diameter on heat transfer characteristics of methane/air flames impinging normally to a flat surface. Three different tubes of internal diameter 8 mm, 9.7 mm and 12 mm were selected as flame holders. Effects of firing rates and equivalence ratios were studied on stagnation point and radial heat flux distribution. Three firing rates (0.25 kW, 0.40 kW and 0.50 kW) and three equivalence ratios (0.8, 1.0 and 1.2) were considered. Stagnation point heat flux was compared for different burner diameters under similar conditions. Radial heat flux distributions over the surface for different burner diameters under different firing rates and equivalence ratios were compared. It was found that the heat flux distribution was intimately related to flame shapes and sizes.

引用

页码：213 / 220

页数：8

共 50 条

[21] Effect of Burner Geometry on Heat Transfer Characteristics of an Impinging Inverse Diffusion Flame Jet with Swirl
Shankar Badiger
V. V. Katti
Vijaykumar Hindasageri
T. R. Anil
[J]. Iranian Journal of Science and Technology, Transactions of Mechanical Engineering, 2021, 45 : 215 - 228
[22] Effect of Burner Geometry on Heat Transfer Characteristics of an Impinging Inverse Diffusion Flame Jet with Swirl
Badiger, Shankar
Katti, V. V.
Hindasageri, Vijaykumar
Anil, T. R.
[J]. IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING, 2021, 45 (01) : 215 - 228
[23] Experimental investigation of the heat transfer characteristics of a pulsating impinging jet on a flat surface
Akdag, Uenal
Akcay, Selma
Karabayir, M. Levent
[J]. JOURNAL OF THE FACULTY OF ENGINEERING AND ARCHITECTURE OF GAZI UNIVERSITY, 2023, 38 (02): : 889 - 899
[24] ON THE HEAT-TRANSFER CHARACTERISTICS OF CONSTRAINED AIR-JETS IMPINGING ON A FLAT SURFACE
SHOUKRI, M
CALKA, A
[J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 1987, 30 (01) : 203 - 205
[25] Heat transfer distribution for impinging methane-air premixed flame jets
Hindasageri, Vijaykumar
Vedula, Rajendra P.
Prabhu, Siddini V.
[J]. APPLIED THERMAL ENGINEERING, 2014, 73 (01) : 461 - 473
[26] Augmentation of Heat Transfer and Investigation of Fluid Flow Characteristics of an Impinging Air Jet on to a Flat Plate
Jeyajothi, K.
Kalaichelvi, P.
[J]. ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING, 2019, 44 (06) : 5289 - 5299
[27] Augmentation of Heat Transfer and Investigation of Fluid Flow Characteristics of an Impinging Air Jet on to a Flat Plate
K. Jeyajothi
P. Kalaichelvi
[J]. Arabian Journal for Science and Engineering, 2019, 44 : 5289 - 5299
[28] Heat transfer characteristics of dual flame with outer swirling and inner non-swirling flame impinging on a flat surface
Singh, Satpal
Chander, Subhash
[J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2014, 77 : 995 - 1007
[29] Experimental heat transfer study of confined flame jet impinging on a flat surface
Hoser, D.
von Rohr, Ph. Rudolf
[J]. EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2018, 91 : 166 - 174
[30] Numerical investigation of the heat transfer characteristics of propane/air flames impinging on a cylindrical surface
Costa, Sergio Cavaleiro
Malico, Isabel
[J]. APPLIED THERMAL ENGINEERING, 2022, 206

← 1 2 3 4 5 →