Carbon influx studies in the main chamber of ASDEX upgrade

被引:20
|
作者
Pütterich, T [1 ]
Dux, R [1 ]
Gafert, J [1 ]
Kallenbach, A [1 ]
Neu, R [1 ]
Pugno, R [1 ]
Yoon, SW [1 ]
机构
[1] Max Planck Inst Plasma Phys, EURATOM Assoc, D-85748 Garching, Germany
关键词
D O I
10.1088/0741-3335/45/10/003
中图分类号
O35 [流体力学]; O53 [等离子体物理学];
学科分类号
070204 ; 080103 ; 080704 ;
摘要
Carbon sources in the main chamber of ASDEX Upgrade, especially the 12 guard limiters at the low field side (LFS), were determined spectroscopically using recently installed lines of sight. Absolute photon fluxes were measured for spectral lines in the visible wavelength range referring to all spin systems of C+1 and C+2. A simple transport model for carbon enabled the simulation of the radial distribution of carbon radiation and the determination of the effective inverse photon efficiency, which was used for the evaluation of ion fluxes. The model also predicts the fraction of eroded particles that are transported out of the plasma before further ionization occurs. Comparison of the calculated losses with measurements showed good agreement in L-mode cases, whereas in H-mode cases the CIII/CII radiation ratio was too high by a factor 1.5. The contribution of each spin system to the ion flux was independently measured. For C+1 and C+2 the spin system distribution was found to be close to equilibrium. The line-of-sight-integrated photon fluxes were spatially separated for many lines of sight by Zeeman-analysis and differential measurements. This allowed us to determine the total influx from the high field side and LFS. Surprisingly, the carbon source at the inner heatshield was larger than the carbon influx from the limiter source at the LFS. This is very pronounced for the H-mode case investigated, where 60-80% of the carbon atoms emerge from the heatshield. This source is due to recycling or re-erosion of carbon, which probably originates from the limiters, because approximate to85% of the heatshield area consisted of tungsten coated tiles.
引用
收藏
页码:1873 / 1892
页数:20
相关论文
共 50 条
  • [41] THE RF SYSTEM AND MATCHING PROCEDURE FOR ASDEX AND ASDEX UPGRADE
    HOFMEISTER, F
    BRAUN, F
    WESNER, F
    FUSION ENGINEERING AND DESIGN, 1994, 24 (1-2) : 83 - 89
  • [42] The fishbone instability in ASDEX upgrade
    Kass, T
    Bosch, HS
    Hoenen, F
    Lackner, K
    Maraschek, M
    Zohm, H
    NUCLEAR FUSION, 1998, 38 (06) : 807 - 819
  • [43] Overview of ASDEX Upgrade results
    Stroth, U.
    Adamek, J.
    Aho-Mantila, L.
    Akaslompolo, S.
    Amdor, C.
    Angioni, C.
    Balden, M.
    Bardin, S.
    Orte, L. Barrera
    Behler, K.
    Belonohy, E.
    Bergmann, A.
    Bernert, M.
    Bilato, R.
    Birkenmeier, G.
    Bobkov, V.
    Boom, J.
    Bottereau, C.
    Bottino, A.
    Braun, F.
    Brezinsek, S.
    Brochard, T.
    Bruedgam, M.
    Buhler, A.
    Burckhart, A.
    Casson, F. J.
    Chankin, A.
    Chapman, I.
    Clairet, F.
    Classen, I. G. J.
    Coenen, J. W.
    Conway, G. D.
    Coster, D. P.
    Curran, D.
    da Silva, F.
    de Marne, P.
    D'Inca, R.
    Douai, D.
    Drube, R.
    Dunne, M.
    Dux, R.
    Eich, T.
    Eixenberger, H.
    Endstrasser, N.
    Engelhardt, K.
    Esposito, B.
    Fable, E.
    Fischer, R.
    Fuenfgelder, H.
    Fuchs, J. C.
    NUCLEAR FUSION, 2013, 53 (10)
  • [44] CHARACTERISTICS OF A FREELY PROGRAMMABLE ICCD DETECTOR FOR MULTICHORD PARTICLE INFLUX MEASUREMENTS ON THE ASDEX-UPGRADE TOKAMAK
    KALLENBACH, A
    MAYER, HM
    REVIEW OF SCIENTIFIC INSTRUMENTS, 1993, 64 (05): : 1257 - 1262
  • [45] Measuring main-ion temperatures in ASDEX Upgrade using scattering of ECRH radiation
    Stejner, M.
    Nielsen, S.
    Jacobsen, A. S.
    Korsholm, S. B.
    Leipold, F.
    McDermott, R. M.
    Rasmussen, J.
    Salewski, M.
    Schubert, M.
    Stober, J.
    Wagner, D. H.
    2016 41ST INTERNATIONAL CONFERENCE ON INFRARED, MILLIMETER, AND TERAHERTZ WAVES (IRMMW-THZ), 2016,
  • [46] ECRH experiments in ASDEX upgrade
    Leuterer, F
    Günter, S
    Maraschek, M
    Ryter, F
    Suttrop, W
    Wolf, R
    Gantenbein, G
    Zohm, H
    FUSION ENGINEERING AND DESIGN, 2001, 53 : 277 - 287
  • [47] ARCING IN ASDEX-UPGRADE
    JUTTNER, B
    BUCHL, K
    WEINLICH, M
    CONTRIBUTIONS TO PLASMA PHYSICS, 1994, 34 (2-3) : 472 - 477
  • [48] Overview of ASDEX Upgrade results
    Kaufmann, M
    Schweinzer, J
    Albrecht, M
    Alexander, M
    Asmussen, K
    Becker, G
    Behler, K
    Behringer, K
    Behrisch, R
    Berger, E
    Bergmann, A
    Bessenrodt-Weberpals, M
    Borrass, K
    Bosch, HS
    Braams, BJ
    Brambilla, M
    Braun, F
    Brinkschulte, H
    Brosig, C
    Büchl, K
    Buhler, A
    Callaghan, H
    Carlson, A
    Chodura, R
    Coster, DP
    Cupido, L
    De Blank, HJ
    Hempel, SD
    Deschka, S
    Dose, V
    Dorn, C
    Dodel, G
    Drube, R
    Dux, R
    Egorov, AS
    Engelhardt, W
    Engstler, J
    Fahrbach, HU
    Fantz, U
    Feist, HU
    Fiedler, S
    Fieg, G
    Field, A
    Franzen, P
    Fuchs, JC
    Fussmann, G
    Gafert, J
    Gantenbein, G
    Garcia-Rosales, G
    Gehre, O
    FUSION ENERGY 1996, VOL 1, 1997, : 79 - 94
  • [49] Overview of ASDEX upgrade results
    Zohm, H
    Angioni, C
    Arslanbekov, R
    Atanasiu, C
    Becker, G
    Becker, W
    Behler, K
    Behringer, K
    Bergmann, A
    Bilato, R
    Bobkov, V
    Bolshukhin, D
    Bolzonella, T
    Borrass, K
    Brambilla, M
    Braun, F
    Buhler, A
    Carlson, A
    Conway, GD
    Coster, DP
    Drube, R
    Dux, R
    Egorov, S
    Eich, T
    Engelhardt, K
    Fahrbach, HU
    Fantz, U
    Faugel, H
    Finken, KH
    Foley, M
    Franzen, P
    Fuchs, JC
    Gafert, J
    Fournier, KB
    Gantenbein, G
    Gehre, O
    Geier, A
    Gernhardt, J
    Goodman, T
    Gruber, O
    Gude, A
    Günter, S
    Haas, G
    Hartmann, D
    Heger, B
    Heinemann, B
    Herrmann, A
    Hobirk, J
    Hofmeister, F
    Hohenöcker, H
    NUCLEAR FUSION, 2003, 43 (12) : 1570 - 1582
  • [50] Wall conditioning in ASDEX upgrade
    Rohde, V.
    Dux, R.
    Kallenbach, A.
    Krieger, K.
    Neu, R.
    JOURNAL OF NUCLEAR MATERIALS, 2007, 363 : 1369 - 1374