Microstructure and Wear Resistance of Plasma-Sprayed Molybdenum Coating Reinforced by MoSi2 Particles

被引：51
|
作者：
Yan, Jianhui [1 ]
He, Zheyu [1 ]
Wang, Yi [1 ]
Qiu, Jingwen [1 ]
Wang, Yueming [1 ]
机构：
[1] Hunan Univ Sci & Technol, Hunan Prov Key Def Lab High Temp Wear Resisting M, Xiangtan, Peoples R China
来源：
JOURNAL OF THERMAL SPRAY TECHNOLOGY | 2016年 / 25卷 / 07期
基金：
中国国家自然科学基金;
关键词：
atmospheric plasma spraying; molybdenum coating; MoSi2; wear resistance; MECHANICAL-PROPERTIES; DEPOSITION; BEHAVIOR; FUEL; MO;
D O I：
10.1007/s11666-016-0440-6
中图分类号：
TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
Mo coatings with or without incorporated MoSi2 were fabricated by atmospheric plasma spraying, and their microstructure, microhardness, bond strength, and wear resistance were compared. Two kinds of spray powder, i.e., pure Mo and a blend of Mo and MoSi2, were sprayed onto low-carbon steel. Microstructural analysis of the MoSi2-Mo coating showed MoSi2 homogeneously distributed in a Mo matrix. Addition of MoSi2 particles increased the microhardness of the as-sprayed Mo coating. The adhesion strength of the Mo coating was better than that of the MoSi2-Mo coating. Wear test results showed that the wear rate and friction coefficient of the two coatings increased with increasing load, and the friction coefficient of the MoSi2-Mo coating was lower than that of the Mo coating. The MoSi2-Mo composite coating exhibited better wear resistance than the Mo coating. The wear failure mechanisms of the two coatings were local plastic deformation, delamination, oxidation, and adhesion wear.
引用
收藏
页码：1322 / 1329
页数：8
相关论文
共 50 条
  • [1] Microstructure and Wear Resistance of Plasma-Sprayed Molybdenum Coating Reinforced by MoSi2 Particles
    Jianhui Yan
    Zheyu He
    Yi Wang
    Jingwen Qiu
    Yueming Wang
    Journal of Thermal Spray Technology, 2016, 25 : 1322 - 1329
  • [2] Microstructure Evolution of Plasma-Sprayed MoSi2 Coating at RT-1200 °C in Air
    Yaran Niu
    Cuihong Zhai
    Guocheng Wang
    Liping Huang
    Xuebin Zheng
    Chuanxian Ding
    Journal of Thermal Spray Technology, 2018, 27 : 938 - 948
  • [3] CREEP-BEHAVIOR OF PLASMA-SPRAYED SIC-REINFORCED MOSI2
    JENG, YL
    LAVERNIA, EJ
    WOLFENSTINE, J
    BAILEY, DE
    SICKINGER, A
    SCRIPTA METALLURGICA ET MATERIALIA, 1993, 29 (01): : 107 - 111
  • [4] Effect of Ni Addition on Microstructure and Tribological Properties of Plasma-Sprayed MoSi2 Coatings
    Xu, Wenfu
    Niu, Yaran
    Ji, Heng
    Li, Hong
    Chang, Chengkang
    Zheng, Xuebin
    JOURNAL OF THERMAL SPRAY TECHNOLOGY, 2018, 27 (08) : 1632 - 1642
  • [5] Effect of Ni Addition on Microstructure and Tribological Properties of Plasma-Sprayed MoSi2 Coatings
    Wenfu Xu
    Yaran Niu
    Heng Ji
    Hong Li
    Chengkang Chang
    Xuebin Zheng
    Journal of Thermal Spray Technology, 2018, 27 : 1632 - 1642
  • [6] Microstructure and Wear Behaviors of Plasma-Sprayed MoAlB Ceramic Coating
    Li, Fuzhu
    Sun, Shengnan
    Xu, Yong
    Tian, Lihui
    Wang, Yun
    Xu, Zhenying
    Li, Ruitao
    COATINGS, 2021, 11 (04)
  • [7] Oxidation behavior of nanostructured and conventional MoSi2 plasma-sprayed coatings
    Erfanmanesh, Mohammad
    Bakhshi, Saeed Reza
    CERAMICS INTERNATIONAL, 2018, 44 (13) : 15839 - 15844
  • [8] Improvement of wear resistance of plasma-sprayed molybdenum blend coatings
    Ahn, J
    Hwang, B
    Lee, S
    JOURNAL OF THERMAL SPRAY TECHNOLOGY, 2005, 14 (02) : 251 - 257
  • [9] GAS-PERMEABILITY OF PLASMA-SPRAYED MOSI(2) COATING
    FUKUMOTO, M
    UEDA, T
    OKANE, I
    JOURNAL OF MATERIALS SCIENCE LETTERS, 1994, 13 (09) : 656 - 657
  • [10] Improvement of wear resistance of plasma-sprayed molybdenum blend coatings
    Jeehoon Ahn
    Byoungchul Hwang
    Sunghak Lee
    Journal of Thermal Spray Technology, 2005, 14 : 251 - 257
12345