Effect of plantar pressure on stepping friction under cross-slope condition

被引:0
|
作者
Wang, Yanzhao [1 ,2 ]
Chen, Deqiang [1 ]
Zhang, Yongzhen [1 ]
Niu, Yongping [1 ]
Yang, Xiaohui [3 ]
机构
[1] Henan Univ Sci & Technol, Natl United Engn Lab Adv Bearing Tribol, Luoyang, Henan, Peoples R China
[2] Henan Univ Sci & Technol, Sch Mat Sci & Engn, Luoyang, Henan, Peoples R China
[3] Henan Univ Sci & Technol, Dept Neurol, Affiliated Hosp 1, Luoyang, Henan, Peoples R China
基金
中国国家自然科学基金;
关键词
cross-slope walkway; slip; spatiotemporal parameters; WALKING; SLIP; COEFFICIENT; LEVEL; BIOMECHANICS; ADAPTATIONS; KINEMATICS; FLOORS;
D O I
10.1049/bsb2.12032
中图分类号
R318 [生物医学工程];
学科分类号
0831 ;
摘要
There are various walking pavements in daily life. Slip accidents will happen if required friction for safe walking is greater than available friction between the foot and ground surface. Existing researches mostly focus on horizontal or slope pavements, whereas the cross-slope walkways are less. A self-developed gait friction test platform was used to test friction, distribution of plantar pressure and spatiotemporal parameters of human walking under cross-slope condition. With the increase of cross-slope angles, the mediolateral friction increases (R-2 = 0.972, P < 0.001), the anterior-posterior friction shows no significant change (R-2 = 0.758, P = 0.017), the normal pressure decreases (R-2 = 0.915, P = 0.007), and the high foot is more prone to slip and fall than low foot. Therefore, plantar pressure distribution of both feet was shifted to left. The gait cycle was prolonged (P < 0.001), swing period of both feet decreased (P = 0.029) and support period increased (P = 0.015) with the increase of cross-slope angle.
引用
收藏
页码:15 / 22
页数:8
相关论文
共 50 条
  • [41] The effect of oil feed pressure on the friction torque of plain bearings under light, steady loads
    Mansoor, Yousuf
    Shayler, Paul
    TRIBOLOGY INTERNATIONAL, 2018, 119 : 316 - 328
  • [42] Effect of Tribochemical Reaction on Friction and Wear of DLC under Lubrication with Ionic Liquids at High-Vacuum Condition
    Sasaki, Shinya
    Yagi, Tsutomu
    Mano, Hiroki
    Miyake, Koji
    Nakano, Miki
    Ishida, Takao
    ADVANCED TRIBOLOGY, 2009, : 886 - +
  • [43] Effect of various additives on the friction and wear properties of high silicon content aluminum alloys under lubricating condition
    Honda, Tomomi
    Takaoka, Naoki
    Kasai, Moritsugu
    Shimizu, Yasunori
    Toraibarojisuto/Journal of Japanese Society of Tribologists, 2017, 62 (01): : 43 - 51
  • [44] Research on the Technical Limit Well Spacing Under the Condition of Variable Starting Pressure Gradient Based on Pressure Sensitivity Effect
    Chi, Bo
    Yan, Qi
    Li, Chenglong
    Xu, Chen
    Zhang, Fugui
    NEW ENERGY AND FUTURE ENERGY SYSTEMS, NEFES 2023, 2023, 45 : 75 - 82
  • [45] Effect of back pressure and freestream dynamic pressure on a typical Ramjet engine duct under realistic supersonic inlet condition
    Saravanan, R.
    Desikan, S. L. N.
    Muruganandam, T. M.
    AERONAUTICAL JOURNAL, 2018, 122 (1247): : 83 - 103
  • [46] Effect of Surcharge Pressure on Model Geotextile Wrapped-Face Wall Under Seismic Condition
    Chakraborty, Sudipta
    Hore, Ripon
    Shuvon, Ayaz Mahmud
    Ansary, Mehedi Ahmed
    IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF CIVIL ENGINEERING, 2022, 46 (06) : 4409 - 4423
  • [47] Effect of Surcharge Pressure on Model Geotextile Wrapped-Face Wall Under Seismic Condition
    Sudipta Chakraborty
    Ripon Hore
    Ayaz Mahmud Shuvon
    Mehedi Ahmed Ansary
    Iranian Journal of Science and Technology, Transactions of Civil Engineering, 2022, 46 : 4409 - 4423
  • [48] Effect of width and slope of large cross-section tunnel on ceiling smoke temperature under natural ventilation
    Liu, Su
    Ye, Chenghao
    Zhang, Peihong
    ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS, 2024, 46 (01) : 3061 - 3081
  • [49] Effect of submicron SiC particle on friction and wear properties of copper matrix composites under oil-lubricated condition
    Dai, F. Z.
    Lu, J. Z.
    Zhang, Y. K.
    Wen, D. P.
    Zhang, L.
    Luo, K. Y.
    Xu, X. J.
    Cai, L.
    ADVANCED COMPOSITE MATERIALS, 2013, 22 (03) : 191 - 202
  • [50] Effect of thickness on buckling of perfect cross-ply rings under external pressure
    Kim, Deokjoo
    Chaudhuri, Reaz A.
    COMPOSITE STRUCTURES, 2007, 81 (04) : 525 - 532