Photocatalytic and Magnetic Porous Cellulose-Based Nanocomposite Films Prepared by a Green Method

The present work expands our previous studies related to cellulose processing with room-temperature ionic liquids and simultaneous integration of functional nanoparticles toward photocatalytically active and easily recyclable nano composite porous films based on a renewable matrix material. Porosity can be tuned by the selection of phase separation conditions for the films obtained from the casting solutions of cellulose in ionic liquids or their mixture with an organic co-solvent. TiO2 nanoparticles confer to the nanocomposite photocatalytic activity, while Fe3O4 nanoparticles make it magnetically active. The photocatalytic activity of the cellulose film containing 10 mg of TiO2 was 1 order of magnitude lower than that of the same amount of pure TiO2 nanopowder, due to the reduction of the active catalytic surface which can be reached by UV irradiation after embedment in the polymer matrix. However, this fixation in a solid polymer support allows facile recovery of the catalyst after use. The rate constant when using the cellulose nanocomposite doped with TiO2 and Fe3O4 (k 0.0019 min(-1)) is very close to that for the corresponding composite containing only TiO2 (k 0.0017 min-1), suggesting that co-doping with Fe3O4 nanoparticles did not diminish the photocatalytic activity of the final composite, which can be easily separated from solution with a magnet. Additionally, by Fe3O4 doping, the composite material's temperature can be homogeneously increased by similar to 12 K via exposure to a high-frequency alternating magnetic field (AMF) for 5 min. For an optimal thermal response to AMF, the magnetite nanoparticles have to be homogeneously dispersed within the polymer matrix. The preparation method for the casting solution has been found to play an essential role for the one-step fabrication of multifunctional cellulose-based nanocomposite materials.