Nanoindentation studies of Zr-based bulk metallic glasses

被引:24
|
作者
Drozdz, D.
Kulik, T.
Fecht, H. J.
机构
[1] Univ Ulm, Fac Engn, Div Mat, D-89081 Ulm, Germany
[2] Warsaw Univ Technol, Fac Mat Sci & Engn, PL-02507 Warsaw, Poland
关键词
bulk metallic glasses; nanoindentation; mechanical properties;
D O I
10.1016/j.jallcom.2006.09.066
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Hardness (H) and Young modulus (E) of three different chemical compositions of Zr-based bulk metallic glasses were investigated through the use of nanoindentation. The effects of the chemical composition and microstructure of bulk metallic glasses on mechanical properties were examined. Additionally, plastic deformation of studied alloys during nanoindentation's measurements, with different indentation-loading rates was carried out. The increase in hardness with the increase of crystalline volume fraction (Vcr) for all alloys was observed. Increasing V(cr), Young modulus of studied alloys increases almost linearly in the range up to about 75%. For fully crystalline alloys small decrease of Young modulus is observed. Alloy C, containing the highest Al amount, exhibits the highest values of H and E among all studied alloys. It was noticed that plastic deformation of amorphous alloys is punctuated by many discrete bursts of rapid displacement. This behaviour showed to be strongly depended on the indentation-loading rate. As the loading rate is increased, the nature of serrated flow observed on load-displacement (P-h) curves, changes significantly. Low rates P-h curves exhibit characteristic serrations, while curves obtained at higher rates are smoother. The character of plastic deformation of partially crystallised alloys was analysed, as well. For those materials, the change in the nature of the plastic deformation, from serrated to non-serrated flow, is observed at lower indentation rates, as compared to results obtained for amorphous alloys. (C) 2006 Elsevier B.V. All rights reserved.
引用
收藏
页码:62 / 65
页数:4
相关论文
共 50 条
  • [21] Microgrinding characteristics of Zr-based bulk metallic glasses
    Liu Yin
    Gong Ya-dong
    Sun Yao
    Zhang Huan
    Li Qiang
    INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 2018, 94 (5-8): : 2401 - 2417
  • [22] Microfracture observation of Zr-based bulk metallic glasses
    Lee, Jung G.
    Sohn, Kee-Sun
    Lee, Sunghak
    Kimd, Nack J.
    Kim, Choongnyun P.
    MECHANICAL BEHAVIOR OF MATERIALS X, PTS 1AND 2, 2007, 345-346 : 645 - +
  • [23] Tough Hypoeutectic Zr-Based Bulk Metallic Glasses
    Yokoyama, Yoshihiko
    Tokunaga, Hitoo
    Yavari, Alain Reza
    Kawamata, Toru
    Yamasaki, Tohru
    Fujita, Kazutaka
    Sugiyama, Kazumasa
    Liaw, Peter K.
    Inoue, Akihisa
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2011, 42A (06): : 1468 - 1475
  • [24] Formation and properties of Zr-based bulk metallic glasses
    Zhang, Yong
    Zhao, Deqian
    Zhuang, Yanxin
    Pan, Mingxiang
    Wang, Weihua
    Jinshu Xuebao/Acta Metallurgica Sinica, 2000, 36 (11): : 1153 - 1156
  • [25] Flow and fracture in Zr-based bulk metallic glasses
    Suh, D
    Dauskardt, RH
    ANNALES DE CHIMIE-SCIENCE DES MATERIAUX, 2002, 27 (05): : 25 - 40
  • [26] Oxygen segregation in the Zr-based bulk metallic glasses
    Cheng, Jia-Lin
    Chen, Guang
    Zhang, Zhong-Wu
    Wang, Zhang-Zhong
    Wang, Zai-You
    Li, Xiao-Quan
    INTERMETALLICS, 2014, 49 : 149 - 153
  • [27] Microgrinding characteristics of Zr-based bulk metallic glasses
    Liu Yin
    Gong Ya-dong
    Sun Yao
    Zhang Huan
    Li Qiang
    The International Journal of Advanced Manufacturing Technology, 2018, 94 : 2401 - 2417
  • [28] Specimen Size Effects on Zr-Based Bulk Metallic Glasses Investigated by Uniaxial Compression and Spherical Nanoindentation
    Bei, H.
    Lu, Z. P.
    Shim, S.
    Chen, G.
    George, E. P.
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2010, 41A (07): : 1735 - 1742
  • [29] Specimen Size Effects on Zr-Based Bulk Metallic Glasses Investigated by Uniaxial Compression and Spherical Nanoindentation
    H. Bei
    Z.P. Lu
    S. Shim
    G. Chen
    E.P. George
    Metallurgical and Materials Transactions A, 2010, 41 : 1735 - 1742
  • [30] Nanoindentation response of an ion irradiated Zr-based bulk metallic glass
    Raghavan, R.
    Kombaiah, B.
    Doebeli, M.
    Erni, R.
    Ramamurty, U.
    Michler, J.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2012, 532 : 407 - 413