Flocculation properties of biodegradable amphoteric chitosan-based flocculants

被引:140
|
作者
Yang, Zhen [1 ]
Shang, Yabo [2 ]
Lu, Yaobo [1 ]
Chen, Yichun [2 ]
Huang, Xin [1 ]
Chen, Aimin [2 ]
Jiang, Yuxiang [2 ]
Gu, Wei [2 ]
Qian, Xiaozhi [2 ]
Yang, Hu [1 ]
Cheng, Rongshi [1 ]
机构
[1] Nanjing Univ, Sch Chem & Chem Engn, Dept Polymer Sci & Technol, Key Lab Mesoscop Chem MOE, Nanjing 210093, Peoples R China
[2] Zhenjiang Water Supply Co, Zhenjiang 212009, Peoples R China
关键词
Amphoteric chitosan-based flocculants; Flocculation properties; Flocculation mechanism; Laboratory scale; Pilot scale; GRAFT-POLYACRYLAMIDE FLOCCULANTS; EQUATION; REMOVAL; WATER;
D O I
10.1016/j.cej.2011.05.106
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
In this study, a kind of amphoteric chitosan-based flocculants (3-chloro-2-hydroxypropyl trimethyl ammonium chloride (CTA) modified carboxymethyl chitosan, denoted as CMC-CTA) have been prepared. The amphoteric flocculants showed notable improvement in solubility and salt-resistance in the whole pH range compared with its precursors, i.e., chitosan and cationic chitosan. The flocculation properties of CMC-CTA were systematically studied at both the laboratory and pilot scales. At laboratory scale, kaolin suspension was employed as synthetic water in the beaker experiment. The effects of pH, temperature, and original turbidity of untreated water on the dosage and flocculation performances were investigated, respectively. At pH below and above the isoelectric point of CMC-CTA, the optimal flocculation performances were obtained with a dosage of 0.03-0.20 mg/L and 0.8-1.0 mg/L, respectively. The flocculation mechanism was discussed in detail from the morphologies of polymeric flocculants and flocculation kinetics: The shape and charge of polymer chains in the solution greatly influenced the final flocculation performances; The flocculation kinetics agreed well with the particle collision model. Moreover, raw water from the Zhenjiang part of the Yangtze River in China was used for the further investigation of the flocculation properties at the pilot scale. The influences of dosage, sedimentation time, and mechanical mixing rate to the flocculation properties were studied by orthogonal testing. The optimal experimental condition was then obtained. Compared with the currently used flocculants in the Zhenjiang Water Factory, i.e., polyferric sulfate, which has an optimal dosage around 40 mg/L, the value of CMC-CTA (1.1 mg/L) decreased greatly. Above all, the flocculation experiments at the laboratory and pilot scales both indicate that the amphoteric chitosan-based flocculants have good flocculation performances in a wide pH range. (C) 2011 Elsevier B.V. All rights reserved.
引用
收藏
页码:287 / 295
页数:9
相关论文
共 50 条
  • [41] Heavy metal removal from aqueous solutions by chitosan-based magnetic composite flocculants
    Xiao, Xuefeng
    Yu, Yuanyuan
    Sun, Yongjun
    Zheng, Xing
    Chen, Aowen
    JOURNAL OF ENVIRONMENTAL SCIENCES, 2021, 108 : 22 - 32
  • [42] Modeling and optimization of the flocculation processes for removal of cationic and anionic dyes from water by an amphoteric grafting chitosan-based flocculant using response surface methodology
    Hu Wu
    Ran Yang
    Ruihua Li
    Chao Long
    Hu Yang
    Aimin Li
    Environmental Science and Pollution Research, 2015, 22 : 13038 - 13048
  • [43] Modeling and optimization of the flocculation processes for removal of cationic and anionic dyes from water by an amphoteric grafting chitosan-based flocculant using response surface methodology
    Wu, Hu
    Yang, Ran
    Li, Ruihua
    Long, Chao
    Yang, Hu
    Li, Aimin
    ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH, 2015, 22 (17) : 13038 - 13048
  • [44] Flocculation of emulsified oil using a novel amphiphilic and cationic chitosan-based flocculant
    Lyu, Ting
    Zhao, Hongting
    ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 2015, 249
  • [45] Emulsified oil removal from steel rolling oily wastewater by using magnetic chitosan-based flocculants: Flocculation performance, mechanism, and the effect of hydrophobic monomer ratio
    Ma, Jiangya
    Wu, Genyu
    Zhang, Rui
    Xia, Wei
    Nie, Yong
    Kong, Yanli
    Jia, Bangtao
    Li, Sha
    SEPARATION AND PURIFICATION TECHNOLOGY, 2023, 304
  • [46] Carboxymethyl Chitosan-based Biodegradable Films Preparation and Prospects for Food Preservation
    Pk., Md. Elius Hosen
    Islam, Md. Monarul
    Akter, Rabeya
    Nesa, Fajilatun
    Rahman, Mohammad Mahbubur
    Paul, Trisha
    Mustafi, Sonjida
    Karim, Md. Rezaul
    Rahman, Shofiur
    Alodhayb, Abdullah N.
    Vasquez-Guardado, Erick S.
    Albrithen, Hamad
    CHEMISTRYSELECT, 2025, 10 (01):
  • [47] Biodegradable membrane-covered stent from chitosan-based polymers
    Thierry, B
    Merhi, Y
    Silver, J
    Tabrizian, M
    JOURNAL OF BIOMEDICAL MATERIALS RESEARCH PART A, 2005, 75A (03) : 556 - 566
  • [48] Kinetics of the release of antibiotics from chitosan-based biodegradable biopolymer membranes
    Sevost'yanov, M. A.
    Fedotov, A. Yu.
    Nasakina, E. O.
    Teterina, A. Yu.
    Baikin, A. S.
    Sergienko, K. V.
    Kolmakov, A. G.
    Komlev, V. S.
    Ivanov, V. E.
    Karp, O. E.
    Gudkov, S. V.
    Barinov, S. M.
    DOKLADY CHEMISTRY, 2015, 465 : 278 - 280
  • [49] Development of bioactive and biodegradable chitosan-based thermo-responsive hydrogels
    Couto, D. S.
    Mano, J. F.
    TISSUE ENGINEERING PART A, 2008, 14 (05) : 836 - 836
  • [50] Kinetics of the release of antibiotics from chitosan-based biodegradable biopolymer membranes
    M. A. Sevost’yanov
    A. Yu. Fedotov
    E. O. Nasakina
    A. Yu. Teterina
    A. S. Baikin
    K. V. Sergienko
    A. G. Kolmakov
    V. S. Komlev
    V. E. Ivanov
    O. E. Karp
    S. V. Gudkov
    S. M. Barinov
    Doklady Chemistry, 2015, 465 : 278 - 280