Thermodynamics assessment on cooling photovoltaic modules by phase change materials (PCMs) in critical operating temperature

Increasing the temperature of photovoltaic (PV) cells decreases their electricity generation. The use of phase change materials (PCMs) is one of the most common methods for controlling the rate of increasing the temperature of PV cells. This research focuses on thermodynamic analysis of PV/PCM systems with and without fins in maximum operating temperature of PV modules (85 degrees C). Polyethylene glycol 600 (PEG-600) and paraffin, with different melting points, have been studied experimentally as PCM in an indoor condition. Moreover, the effect of using fins was investigated. For this critical temperature, the results showed that using paraffin could be better for controlling the temperature of PV cells, due to its closer melting point with the module temperature. In the case of fins included, the temperature differences of 28.0 degrees C and 8.8 degrees C between the case of paraffin + fin and the case of PEG 600 + fin in comparison with the conventional PV module were measured, respectively. At this critical temperature condition, the output power of a PV module cannot exceed the half of its nominal power. The exergy efficiency of the paraffin + fin case was measured to 4.2% more than the conventional one. Also, entropy generation was calculated and reduction up to 5% was shown for paraffin + fin in comparison with the conventional one. Moreover, variations of the Rayleigh number for proposed cases are calculated too.