Mechanistic investigation of nonisothermal suspension polymerization of vinyl chloride

Vinyl chloride suspension polymerization using different temperature trajectories was carried out in a pilot scale batch reactor. Detailed understanding of the conversion at which the primary particles become motionless (X-m) and the key effects of X-m on morphology development of PVC grains were provided. Motionless conversion is estimated for poly(vinyl chloride) (PVC) grains prepared with different temperature trajectories by cold plasticizer absorption measurements. The porosity of PVC grains (prepared isothermally and nonisothermally) shows a maximum at a certain conversion that is considered motionless conversion. With increasing monomer conversion, the cold plasticizer uptake decreases dramatically with conversions greater than motionless conversion until the monomer phase is completely exhausted (X-f) and continues to slightly decrease after X-f. The decrease in cold plasticizer absorption is more pronounced for PVC grains produced nonisothermally by lower initial temperature. The results obtained by scanning electron microscopy and Brabender((R)) plastography showed that the changes in internal structure and fusion behavior of PVC grains after X-m would be much lower when early aggregates of primary particles are formed. Scanning electron microscopy photographs indicate that applying the variable temperature with negative slope accelerates networking between the primary particles inside the polymerizing monomer droplets. The Brabender((R)) plastograph measurements indicate a lower time and temperature of fusion and a higher degree of gelation for nonisothermally produced resin in which the temperature trajectory follows a greater negative slope. J. VINYL ADDIT. TECHNOL., 24:84-92, 2018. (c) 2015 Society of Plastics Engineers