The PreProcessors for the ATLAS Tile Calorimeter Phase II Upgrade

被引：0

作者：

Carrio, F. ^{[1
]}

Alvarez, D. ^{[1
]}

Castillo, V. ^{[1
]}

Cerda, L. ^{[1
]}

Ferrer, A. ^{[1
]}

Fiorini, L. ^{[1
]}

Hernandez, Y. ^{[1
]}

Higon, E. ^{[1
]}

Morcno, P. ^{[1
,2
]}

Solans, C. ^{[3
]}

Valero, A. ^{[1
]}

Valls, J. A. ^{[1
]}

机构：

[1] Inst Fis Corpuscular CSIC UV, Catedrat Jose Beltran 2, Paterna, Spain

[2] Univ Witwatersrand, ZA-2000 Johannesburg, South Africa

[3] CERN, Phys Dept, CH-1211 Geneva, Switzerland

来源：

2015 IEEE NUCLEAR SCIENCE SYMPOSIUM AND MEDICAL IMAGING CONFERENCE (NSS/MIC) | 2015年

关键词：

D O I：

暂无

中图分类号：

R8 [特种医学]; R445 [影像诊断学];

学科分类号：

1002 ; 100207 ; 1009 ;

摘要：

The Large Hadron Collider has envisaged a series of upgrades towards a High Luminosity LHC delivering five times the LHC nominal instantaneous luminosity. The ATLAS Phase II Upgrade will accommodate the detector and data acquisition system for the HL-LHC. In particular, the Tile Hadronic Calorimeter will completely replace front-end and back-end electronics using a new read-out architecture. The digitized detector data will be transferred for every beam crossing to the PreProcessors located in off-detector counting rooms with a total data bandwidth of roughly 80 Tbps. The TilePPr implements larger pipelines memories and must provide pre-processed digital trigger information to Level 0/1 trigger systems. The TilePPr system represents the link between the front-end electronics and the overall ATLAS data acquisition system. It also implements the interface between the Detector Control System and the frontend electronics which is used to control and monitor the high voltage distribution system. The TilePPr is responsible of transmitting the commands to configure, control and monitor the front-end electronics.

引用

页数：3

共 50 条

[31] Development of a digital readout board for the ATLAS Tile Calorimeter upgrade demonstrator
Muschter, S.
Aakerstedt, H.
Anderson, K.
Bohm, C.
Oreglia, M.
Tang, F.
JOURNAL OF INSTRUMENTATION, 2014, 9
[32] Upgrade of ATLAS hadronic Tile Calorimeter for the High-Luminosity LHC
Peralva, Bernardo Sotto-Maior
NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION A-ACCELERATORS SPECTROMETERS DETECTORS AND ASSOCIATED EQUIPMENT, 2022, 1038
[33] Test Beam Studies for the ATLAS Tile Calorimeter Upgrade Readout Electronics
Rodriguez, Andrea
18TH INTERNATIONAL CONFERENCE ON CALORIMETRY IN PARTICLE PHYSICS (CALOR2018), 2019, 1162
[34] Upgrade for the ATLAS Tile Calorimeter Readout Electronics at the High Luminosity LHC
Cerqueira, A. S.
XVTH INTERNATIONAL CONFERENCE ON CALORIMETRY IN HIGH ENERGY PHYSICS (CALOR2012), 2012, 404
[35] Upgrade for the ATLAS Tile Calorimeter Readout Electronics at the High Luminosity LHC
Carrio, F.
NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION A-ACCELERATORS SPECTROMETERS DETECTORS AND ASSOCIATED EQUIPMENT, 2013, 718 : 69 - 71
[36] Development of a readout link board for the demonstrator of the ATLAS Tile calorimeter upgrade
Muschter, S.
Anderson, K.
Bohm, C.
Eriksson, D.
Oreglia, M.
Tang, F.
JOURNAL OF INSTRUMENTATION, 2013, 8
[37] Erratum to: Upgrade of the ATLAS Hadronic Tile Calorimeter for the High Luminosity LHC
Christophe Clement
Physics of Atomic Nuclei, 2022, 85 : 144 - 144
[38] The Data Acquisition System for the ATLAS Phase-II Tile Calorimeter Demonstrator
Carrio Argos, Fernando
ANIMMA 2021 - ADVANCEMENTS IN NUCLEAR INSTRUMENTATION MEASUREMENT METHODS AND THEIR APPLICATIONS, 2021, 253
[39] The ATLAS Tile Calorimeter
Henriques, A.
2015 4TH INTERNATIONAL CONFERENCE ON ADVANCEMENTS IN NUCLEAR INSTRUMENTATION MEASUREMENT METHODS AND THEIR APPLICATIONS (ANIMMA), 2015,
[40] Calibration system of the ATLAS Tile Calorimeter and its upgrade for HL-LHC
Floris, Viola
NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION A-ACCELERATORS SPECTROMETERS DETECTORS AND ASSOCIATED EQUIPMENT, 2025, 1070

← 1 2 3 4 5 →