A novel design of hybrid high-temperature solar receiver and thermochemical energy storage system

被引:5
|
作者
Ebadi, Mehdi [1 ]
Mehrpooya, Mehdi [2 ]
Kani, Alireza H. [1 ]
机构
[1] Islamic Azad Univ, Fac Nat Resources & Environm, Sci & Res Branch, Tehran, Iran
[2] Univ Tehran, Dept Renewable Energies & Environm, Fac New Sci & Technol, Tehran, Iran
关键词
Gas-phase receivers; Heat transfer enhancement; Thermochemical energy storage; CFD modeling; Hybrid storage; Redox pair; HEAT-TRANSFER CHARACTERISTICS; OXIDE-BASED HONEYCOMBS; PHASE-CHANGE MATERIALS; CAVITY RECEIVER; THERMAL PERFORMANCE; ELECTRONICS DEVICES; PRESSURE; SINKS; FLOW;
D O I
10.1016/j.enconman.2021.114911
中图分类号
O414.1 [热力学];
学科分类号
摘要
Small-scale concentrated solar powers (CSP) integrated with micro gas turbines can be mentioned as an effective way to power off-grid and rural areas. One of the most important challenges of using such no fuel-assisted systems is the intermittent nature of solar radiation and unavailability at nights. To overcome this issue, in this research new design for a high temperature solar receiver combined with a triple (sensible, latent, and chemical) storage was presented. In the first part, solutions to increase heat transfer to reach higher outlet temperature of the solar receiver to integrate with the thermochemical reactor are presented. For this purpose, three new pipe models including sinusoidal, triangular, and trapezoidal tubes are proposed instead of straight tubes. Based on the results, Corrugated tubes have significantly higher heat transfer as well as more pumping power compared to straight tubes and the sinusoidal model has the best thermal-hydraulic performance. In the second part, numerical modeling of a thermochemical reactor with honeycomb structure, which uses Co3O4/CoO as a redox pair, is performed and the results of the developed model are validated against the experimental results and two important parameters in the reactor design including cell density and channel wall thickness of the honeycomb structure is investigated. In the last section, the designed solar receiver is integrated with a thermochemical heat storage, and the performance evaluation of solar receiver integrated with triple storage are presented. The results delighted that the designed solar receiver hybrid with thermochemical energy storage, with the solar receiver efficiency of 68% and energy storage capacity of 137 MJ is capable to provide the required inlet temperature of turbine (1073 K) about 100 min in off-sun condition. In addition, the new design, by meeting the main constraints provided by the micro-gas turbine, has the ability to store up to three times more energy than the latent heat storage alone.
引用
收藏
页数:22
相关论文
共 50 条
  • [41] Thermochemical energy storage at high temperature for concentrated solar power plants: a critical review
    Bielsa, Daniel
    Faik, Abdessamad
    Arias, Pedro L.
    [J]. DYNA, 2023, 98 (06): : 612 - 619
  • [42] Optimal Design and Operation of a Solar Energy Receiver and Storage
    Ghobeity, Amin
    Mitsos, Alexander
    [J]. JOURNAL OF SOLAR ENERGY ENGINEERING-TRANSACTIONS OF THE ASME, 2012, 134 (03):
  • [43] High-temperature phase change materials for short-term thermal energy storage in the solar receiver: Selection and analysis
    Bashir, Muhammad Anser
    Giovannelli, Ambra
    Amber, Khuram Pervez
    Khan, Muhammad Sajid
    Arshad, Adeel
    Daabo, Ahmed M.
    [J]. JOURNAL OF ENERGY STORAGE, 2020, 30
  • [44] System Design of a High-Temperature Downhole Transceiver: Part I - Receiver
    Kerrigan, Brannon
    Pour, Fariborz Lohrabi
    Ha, Dong Sam
    [J]. 2019 IEEE 62ND INTERNATIONAL MIDWEST SYMPOSIUM ON CIRCUITS AND SYSTEMS (MWSCAS), 2019, : 818 - 821
  • [45] Simulation on a novel solar high-temperature thermochemical coupled phase-change reactor
    Ma, T. T.
    Zhu, Y. Z.
    Chen, H. J.
    Ma, Y.
    Yang, L.
    [J]. INTERNATIONAL CONFERENCE ON CONCENTRATING SOLAR POWER AND CHEMICAL ENERGY SYSTEMS, SOLARPACES 2014, 2015, 69 : 471 - 480
  • [46] Modelling and testing of a solar-receiver system applied to high-temperature processes
    Roldan, M. I.
    Zarza, E.
    Casas, J. L.
    [J]. RENEWABLE ENERGY, 2015, 76 : 608 - 618
  • [47] CONSTRUCTION AND TESTING OF A CERAMIC PANEL PIPING SYSTEM FOR A SOLAR HIGH-TEMPERATURE RECEIVER
    MELCHIOR, E
    PAYOME, J
    [J]. BRENNSTOFF-WARME-KRAFT, 1990, 42 (06): : 354 - 361
  • [48] EXPERIMENTAL SETUP OF A LASER DIAGNOSTICS SYSTEM FOR A HIGH-TEMPERATURE SOLAR RECEIVER REACTOR
    STEINFELD, A
    BOMBACH, R
    HAUETER, P
    HEMMERLING, B
    KREUTNER, W
    THOMPSON, G
    WUILLEMIN, D
    [J]. JOURNAL OF SOLAR ENERGY ENGINEERING-TRANSACTIONS OF THE ASME, 1994, 116 (04): : 206 - 211
  • [49] The effect of the gas-solid contacting pattern in a high-temperature thermochemical energy storage on the performance of a concentrated solar power plant
    Strohle, S.
    Haselbacher, A.
    Jovanovic, Z. R.
    Steinfeld, A.
    [J]. ENERGY & ENVIRONMENTAL SCIENCE, 2016, 9 (04) : 1375 - 1389
  • [50] Investigation of Zr-doped CaMnO3 perovskite solid solution for high-temperature solar thermochemical energy storage
    Jin, Fei
    Xu, Chao
    Zhang, HuaJing
    Xu, BoWen
    Liao, ZhiRong
    [J]. Zhongguo Kexue Jishu Kexue/Scientia Sinica Technologica, 2022, 52 (08): : 1223 - 1232