Nonhomogeneous microstructure formation and its role on tensile and fatigue performance of duplex stainless steel 2205 multi-pass weld joints

In this study, the microstructure characteristics and formation mechanism of DSS (duplex stainless steel) multipass weld joints were firstly investigated in terms of the OM (optical microscope) and EBSD (electron back-scattered diffraction) observation, and a series mechanical tests, including the monotonic tensile tests assisted by the DIC (digital image correlation) observation and stress-controlled fatigue tests, were subsequently performed to clarify the intrinsic correlation between mechanical behavior and microstructure. The fatigue fracture morphologies and cracks propagation behavior were analyzed by the OM and SEM (scanning electron microscope) observation. The results show that the significant ferritiszation and determined precipitations were found at the HAZ (heat-affected zone), whereas the austenite was dominating at weld filler zone due to the more formation of the IGA (intragranular austenite). A nearly balance phase ratio was obtained at weld back and cap zones, but the strip GBA (grain boundary austenites) was connected into piece along thickness direction. The monotonic tensile strength of weld joints was higher than that of the based materials due to the refined-grains structures, and the final rupture occurred at the BM (based material) zone. However, the fatigue lifetimes of weld joints were much shorter than that of based materials for the same cyclic amplitude. The fatigue cracks preferred to nucleate at weld back or cap passes although where phase ratio was approximately balance. The austenitic grains which were connected into pieces accelerated the initiation of fatigue cracks. Apart from maintaining phases balance and avoiding detrimental precipitation, the alternative distribution of austenite and ferrite should also be obtained in the engineering.