The evolution of microstructure due to heat treatment on highly porous copper/silver systems

被引：0
|
作者：
Murtha, Brian A. [1 ]
Kulkarni, Anil K.
Singh, Jogender [1 ]
机构：
[1] Penn State Univ, Dept Eng Sci & Mech, University Pk, PA 16801 USA
来源：
PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION 2007, VOL 8, PTS A AND B: HEAT TRANSFER, FLUID FLOWS, AND THERMAL SYSTEMS | 2008年
关键词：
D O I：
暂无
中图分类号：
O414.1 [热力学];
学科分类号：
摘要：
The sintering phenomenon is examined in highly porous materials by first cold pressing powdered copper and silver and separately heat treating them in an un-pressurized furnace. The initial microstructure prior to heat treatment as compared to that after heat treatment showed similar characteristics regardless of the material or powder geometry. However after heat treatment, there are significantly different microstructures among samples. The microstructures depend on the maximum furnace temperature, the particle geometry, material composition, and the particle surface area. While the microstructures change significantly, there is no change in porosity between pre- and post- heat treated samples.
引用
收藏
页码：971 / 977
页数：7
相关论文
共 50 条
  • [41] Microstructure evolution of DD6 during different heat treatment conditions
    Huang, Yao
    Zhao, Chengzhi
    Li, Ning
    Zhang, Hexin
    Yu, Jian
    Li, Jiarong
    MATERIALS RESEARCH EXPRESS, 2020, 7 (01)
  • [42] Microstructure evolution and mechanical properties of disk superalloy under multiplex heat treatment
    Jia, C. L.
    Ge, C. C.
    Yan, Q. Z.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2016, 659 : 287 - 294
  • [43] Influence of Heat Treatment Temperature on the Microstructure Evolution of Poly(vinylborosiloxane) Derived Ceramics
    Deepa Devapal
    K. J. Sreejith
    B. Swaminathan
    Srinivas Chinthalapalli
    S. Bhuvaneswari
    S. Packirisamy
    Journal of Inorganic and Organometallic Polymers and Materials, 2020, 30 : 2224 - 2233
  • [44] Nanocrystallization of a quenched RAFM steel and microstructure evolution during annealing heat treatment
    Liu, W. B.
    Zhang, C.
    Yang, Z. G.
    Xia, Z. X.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2013, 583 : 61 - 68
  • [45] Simulation of the Microstructure Evolution during Directional Solidification and Solution Heat Treatment of Superalloys
    Warnken, Nils
    Ma, Dexin
    Drevermann, Anne
    Steinbach, Ingo
    Fries, Suzana G.
    TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS, 2007, 60 (2-3) : 293 - 297
  • [46] Effect of Heat Treatment on Microstructure and Properties Evolution of Stainless Steel Cladding Plate
    Li, Luyan
    Zhao, Boshen
    Chen, Yongtong
    Ding, Yi
    MATERIALS, 2023, 16 (13)
  • [47] Investigation on Microstructure Evolution of Aviation Bearing Steel During Carburizing Heat Treatment
    Jiang, Xia-Xia
    Jia, Tao
    Wang, Hui
    Wang, Zhao-Dong
    Dongbei Daxue Xuebao/Journal of Northeastern University, 2021, 42 (12): : 1701 - 1708
  • [48] Microstructure evolution and thermal conductivity of diamond/SiC composites after heat treatment
    Pengfei Liu
    YiWei Chen
    Zijian Zhang
    Xinbo He
    Xuanhui Qu
    Journal of Materials Science, 2022, 57 : 21296 - 21308
  • [49] Influence of Heat Treatment Temperature on the Microstructure Evolution of Poly(vinylborosiloxane) Derived Ceramics
    Devapal, Deepa
    Sreejith, K. J.
    Swaminathan, B.
    Chinthalapalli, Srinivas
    Bhuvaneswari, S.
    Packirisamy, S.
    JOURNAL OF INORGANIC AND ORGANOMETALLIC POLYMERS AND MATERIALS, 2020, 30 (06) : 2224 - 2233
  • [50] Microstructure evolution and thermal conductivity of diamond/SiC composites after heat treatment
    Liu, Pengfei
    Chen, YiWei
    Zhang, Zijian
    He, Xinbo
    Qu, Xuanhui
    JOURNAL OF MATERIALS SCIENCE, 2022, 57 (46) : 21296 - 21308
12345