Growth characteristics of Cu(In,Ga)Se2 thin films using 3-stage deposition process with a NaF precursor

被引:22
|
作者
Sakdanuphab, R. [1 ,2 ]
Chityuttakan, C. [1 ,2 ]
Pankiew, A. [3 ]
Somwang, N. [3 ]
Yoodee, K. [1 ,2 ]
Chatraphorn, S. [1 ,2 ]
机构
[1] Chulalongkorn Univ, Dept Phys, Fac Sci, Bangkok 10330, Thailand
[2] CHE, Res Ctr Thin Film Phys, Thailand Ctr Excellence Phys, Bangkok 10400, Thailand
[3] Thai Microelect Ctr, Chachoengsao 24000, Thailand
关键词
Cu(In; Ga)Se-2; Na precursor; MBD; 3-stage growth process; Solar cell; STRUCTURAL-PROPERTIES; SOLAR-CELLS; CUINSE2;
D O I
10.1016/j.jcrysgro.2011.01.077
中图分类号
O7 [晶体学];
学科分类号
0702 ; 070205 ; 0703 ; 080501 ;
摘要
Cu(In,Ga)Se-2 or CIGS thin films with NaF precursor are grown on Mo coated soda-lime glass (SLG) substrates using a molecular beam deposition (MBD) technique. The growth characteristics of the CIGS films deposited using the 3-stage process are examined by interrupting the deposition process at the end of each stage and the transition temperature at the beginning of the second stage. The evolution of the CIGS films derived from the compounds, e.g. gamma-(In,Ga)(2)Se-3, Cu(In,Ga)Se-2+CuxSe, is investigated by comparing the properties of the films to those without an NaF precursor. The XRD spectra show the dominant peak of (1 0 5) preferred orientation of the gamma-(In,Ga)(2)Se-3 enhanced by the NaF precursor which is seen at the end of the first stage. The decrease of (2 2 0)(2 0 4) intensity of the CIGS film is found at the end of the second stage followed by the increase of (1 1 2) intensity at the end point. The AFM images at the end of the first stage show a smooth surface with similar grain shape in the films with the NaF precursor. During the second stage, the grain size of the Cu-rich CIGS film increases with slightly sharper grain boundaries. However, at the end point, the CIGS film is fully obtained and shows small sharp grains corresponding to the increase of (1 1 2) orientation. The cross-section SEM images show small columnar grains with deep grain boundaries at the end point. The AES depth profiles show that most Na atoms are located near the bottom layer in the first stage and diffuse to the surface of the film after increasing the temperature. Then the Na atoms uniformly distribute into the Cu-rich CIGS film during the second stage. Significantly high Na content is found at the surface of the CIGS film at the end point. In addition, a gradient of Ga composition in the CIGS film is also observed in the AES measurement. A simple model of Na-enhanced CIGS thin film growth based on the experimental results is proposed to describe the growth and doping mechanisms. (C) 2011 Elsevier B.V. All rights reserved.
引用
收藏
页码:44 / 48
页数:5
相关论文
共 50 条
  • [41] Fabrication of Cu(In,Ga)Se2 thin films solar cell by selenization process with Se vapor
    Li, W
    Sun, Y
    Liu, W
    Zhou, L
    SOLAR ENERGY, 2006, 80 (02) : 191 - 195
  • [42] Preparation of Zn Doped Cu(In,Ga)Se2 Thin Films by Physical Vapor Deposition
    Nishiwaki, Shiro
    Satoh, Takuya
    Hashimoto, Yasuhiro
    Shimakawa, Shin-ichi
    Hayashi, Shigeo
    Negami, Takayuki
    Wada, Takahiro
    JAPANESE JOURNAL OF APPLIED PHYSICS, 2000, 39 (01) : 155 - 157
  • [43] Properties of Cu(In,Ga,Al)Se2 thin films fabricated by pulsed laser deposition
    Chen, Weiru
    Cao, Wei
    Hameed, Talaat A.
    Marsillac, Sylvain
    Elsayed-Ali, Hani E.
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2015, 26 (03) : 1743 - 1747
  • [44] Post Deposition Treatments of (Ag,Cu)(In,Ga)Se2 Thin Films for Solar Cells
    Edoff, Marika
    Torndahli, Tobias
    Larsson, Fredrik
    Stolt, Olof
    Shariati-Nilsson, Nina
    Stolt, Lars
    2019 IEEE 46TH PHOTOVOLTAIC SPECIALISTS CONFERENCE (PVSC), 2019, : 618 - 621
  • [45] Persistent photoconductivity in Cu(In,Ga)Se2 heterojunctions and thin films prepared by sequential deposition
    Rau, U
    Schmitt, M
    Parisi, J
    Riedl, W
    Karg, F
    APPLIED PHYSICS LETTERS, 1998, 73 (02) : 223 - 225
  • [46] Properties of Cu(In,Ga,Al)Se2 thin films fabricated by pulsed laser deposition
    Weiru Chen
    Wei Cao
    Talaat A. Hameed
    Sylvain Marsillac
    Hani E. Elsayed-Ali
    Journal of Materials Science: Materials in Electronics, 2015, 26 : 1743 - 1747
  • [47] Cu(In,Ga)Se2 films obtained from γ-In2Se3 thin film
    Amory, C
    Bernède, JC
    Halgand, E
    Marsillac, S
    THIN SOLID FILMS, 2003, 431 : 22 - 25
  • [48] Cu(In,Ga)Se2 absorber thinning and the homo-interface model: Influence of Mo back contact and 3-stage process on device characteristics
    Leonard, E.
    Arzel, L.
    Tomassini, M.
    Zabierowski, P.
    Fuertes Marron, D.
    Barreau, N.
    JOURNAL OF APPLIED PHYSICS, 2014, 116 (07)
  • [49] Impact of Se flux on the defect formation in polycrystalline Cu(In,Ga)Se2 thin films grown by three stage evaporation process
    Islam, M. M.
    Uedono, A.
    Sakurai, T.
    Yamada, A.
    Ishizuka, S.
    Matsubara, K.
    Niki, S.
    Akimoto, K.
    JOURNAL OF APPLIED PHYSICS, 2013, 113 (06)
  • [50] The role of In2Se3 precursor properties in multi-stage Cu(In,Ga)Se2 fabrication
    Eisgruber, IL
    Treece, RE
    Marshall, C
    Engel, JR
    CONFERENCE RECORD OF THE TWENTY-EIGHTH IEEE PHOTOVOLTAIC SPECIALISTS CONFERENCE - 2000, 2000, : 684 - 687