Laminar flame speeds and ignition delay times for isopropyl nitrate and propane blends

被引:12
|
作者
Fuller, Mark E. [1 ,3 ]
Mousse-Rayaleh, Ayan [2 ]
Chaumeix, Nabiha [2 ]
Goldsmith, C. Franklin [1 ]
机构
[1] Brown Univ, Sch Engn, 184 Hope St, Providence, RI 02912 USA
[2] CNRS, INSIS, ICARE, 1C Ave Rech Snent, F-45071 Orleans 2, France
[3] Rhein Westfal TH Aachen, Physico Chem Fundamentals Combust, Schinkelstr 8, D-52062 Aachen, Germany
基金
美国国家科学基金会;
关键词
Nitrate; Laminar flame speeds; Ignition delay; Propane; BURN RATE CHARACTERIZATION; THERMAL-DECOMPOSITION; RAPID COMPRESSION; COMBUSTION PROPERTIES; HIGH-TEMPERATURE; RCCI COMBUSTION; HIGH-EFFICIENCY; SHOCK-WAVES; KINETICS; DISSOCIATION;
D O I
10.1016/j.combustflame.2022.112187
中图分类号
O414.1 [热力学];
学科分类号
摘要
Laminar flame speed and ignition delay time measurements are presented for blends of isopropyl-nitrate and propane. The laminar flame speeds were measured in a spherical bomb, with the majority of the experiments performed at 373 K and 1 bar, with equivalence ratios between 0.6 < Phi < 2.1; the fuel composition was 0%, 10%, and 100% isopropyl-nitrate. Additional experiments were performed at 300 K for pure propane as a fuel, and at 0.5 bar for pure isopropyl-nitrate as fuel. The ignition delay measurements were performed in a shock tube, with reflected shock temperatures between 1050 K and 1530 K and a nominal reflected shock pressure of 20 bar. Equivalence ratios of 0.5, 1.0, and 1.5 were considered for fuel blends with 0% and 1% isopropyl-nitrate in propane; additional experiments were performed with 10% isopropyl-nitrate at Phi = 1. In comparison with the pure propane flames, the pure isopropyl-nitrate have a similar peak flame speed ( S L0 = 60 . 3 cm/s at Phi = 1 . 09 for isopropyl-nitrate versus S L0 = 57 . 9 cm/s at Phi = 1 . 10 for propane), but the nitrate is considerably faster under fuel lean conditions, and it exhibits a much broader domain. The ignition delay times for 1% isopropyl-nitrate in propane are indistinguishable from the pure propane experiments for all three equivalence ratios. The 10% isopropyl-nitrate in propane mixture, in contrast, is significantly more reactive. Transition state theory calculations were performed for select RH + NO 2 reactions. These calculations were added to a recently developed mechanism for isopropyl-nitrate and propane. Detailed simulations of the experiments were performed in CANTERA . The agreement between the models and experiments is excellent. The largest discrepancies occur for the ignition delay times for 10% isopropyl-nitrate at T 5 < 1150 K and for the flame speeds for Phi > 1 . 8 , which suggests that further work needs to be done under these conditions. To the best of our knowledge, these data represent the first published results on the laminar flame speeds of any alkyl nitrate.(c) 2022 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
引用
收藏
页数:17
相关论文
共 50 条
  • [41] Effects of mixture composition, dilution level and pressure on auto-ignition delay times of propane mixtures
    Sabia, P.
    de Joannon, M.
    Sorrentino, G.
    Giudicianni, P.
    Ragucci, R.
    CHEMICAL ENGINEERING JOURNAL, 2015, 277 : 324 - 333
  • [42] Effects of mixture composition, dilution level and pressure on auto-ignition delay times of propane mixtures
    Sabia, P.
    de Joannon, M.
    Sorrentino, G.
    Giudicianni, P.
    Ragucci, R.
    Chemical Engineering Journal, 2015, 277 : 324 - 333
  • [43] Shock tube and modeling study of ignition delay times of propane mixtures in ultra-lean conditions
    Xia, Wenxiang
    Zou, Chun
    Lu, Zuan
    Guo, Kexiang
    Qu, Yanping
    Lin, Qianjin
    Jiang, Tong
    COMBUSTION AND FLAME, 2023, 254
  • [44] Ignition delay time and laminar flame speed measurements of mixtures containing diisopropyl-methylphosphonate (DIMP)
    Mathieu, Olivier
    Sikes, Travis
    Kulatilaka, Waruna D.
    Petersen, Eric L.
    COMBUSTION AND FLAME, 2020, 215 : 66 - 77
  • [45] Experimental and modeling study on ignition delay times of dimethoxy methane/n-heptane blends
    Hu, Erjiang
    Gao, Zhenhua
    Liu, Yang
    Yin, Geyuan
    Huang, Zuohua
    FUEL, 2017, 189 : 350 - 357
  • [46] Ignition Delay Times and Chemical Reaction Kinetic Analysis for the Ammonia-Natural Gas Blends
    Liu, Biao
    Zhou, Mengni
    Zhang, Zunhua
    Mi, Xiaoxiong
    Belal, Belal Y.
    Li, Gesheng
    ENERGY & FUELS, 2024, 38 (02) : 1373 - 1382
  • [47] Measurements of propane-O 2-Ar laminar flame speeds at temperatures exceeding 1000 K in a shock tube
    Susa, Adam J.
    Zheng, Lingzhi
    Hanson, Ronald K.
    PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2023, 39 (02) : 1793 - 1802
  • [48] An experimental investigation of ethylene/O2/diluent mixtures:: Laminar flame speeds with preheat and ignition delays at high pressures
    Kumar, Kamal
    Mittal, Gaurav
    Sung, Chih-Jen
    Law, Chung K.
    COMBUSTION AND FLAME, 2008, 153 (03) : 343 - 354
  • [49] Experimental and Modeling Study on Ignition Delay Times of Dimethyl Ether/Propane/Oxygen/Argon Mixtures at 20 bar
    Hu, Erjiang
    Zhang, Zihang
    Pan, Lun
    Zhang, Jiaxiang
    Huang, Zuohua
    ENERGY & FUELS, 2013, 27 (07) : 4007 - 4013
  • [50] Further study on the ignition delay times of propane-hydrogen-oxygen-argon mixtures: Effect of equivalence ratio
    Tang, Chenglong
    Man, Xingjia
    Wei, Liangjie
    Pan, Lun
    Huang, Zuohua
    COMBUSTION AND FLAME, 2013, 160 (11) : 2283 - 2290