Influence of Biodegradable Release Oils on the Physical and Mechanical Properties of Light-Colored Architectural Concrete

In the article, unique formulations of biodegradable, non-toxic, edible oil-based release oils were developed and tested on architectural concrete. The produced agents have physicochemical properties similar to diesel fuel, but at the same time, are renewable and biodegradable products. An ultrasound was used to properly combine the liquid phase of edible oil and the liquid phase of glyceryl trioleate and/or water. Based on the PN-B-19305 standard, seven-component configurations were designed and then tested. The wettability of the concrete was determined by contact angle (CA) analysis. After the application of the formulations produced, the architectural concrete still had good wettability. The vapor permeability test showed that the tested release agents did not inhibit water vapor diffusion from the tested samples. The O65G35 (65% unique edible oil formula and 35% glyceryl trioleate) concrete had the best absorption. In this case, the CA was 56 degrees after oil application and 46 degrees before. The new agents did not impair the adhesion of the plaster to concrete. The O90W10 concrete showed the best adhesion of plasters made with it-51.9 kN/m(2). The study also showed that the concrete surface had excellent paint absorption despite the use of release agents. The architectural concrete was evenly covered with paint without any problem. There were no difficulties in applying it, e.g., greasy places preventing the concrete from being coated with emulsion. The suitability of the produced release oils for lightweight architectural concrete structures intended for facades was confirmed. The best results were obtained after using formulations O65T35 and O90W10.