Corrosion and mechanical properties of duplex-treated 301 stainless steel

被引:24
|
作者
Azzi, M. [1 ]
Benkahoul, M. [1 ]
Klemberg-Sapieha, J. E. [1 ]
Martinu, L. [1 ]
机构
[1] Ecole Polytech, Dept Engn Phys, Montreal, PQ H3C 3A7, Canada
来源
SURFACE & COATINGS TECHNOLOGY | 2010年 / 205卷 / 05期
关键词
Duplex treatment; Plasma nitriding; Cr-Si-N; Magnetron sputtering; Corrosion; EIS; CHEMICAL-VAPOR-DEPOSITION; SI-N COATINGS; TRIBOLOGICAL PROPERTIES; PITTING CORROSION; CREVICE CORROSION; HARD CHROMIUM; RESISTANCE; TEMPERATURE; NITROGEN; HVOF;
D O I
10.1016/j.surfcoat.2010.08.155
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Plasma nitriding is a widely used technique for increasing the surface hardness of stainless steels, and consequently, for improving their tribological properties. It is also used to create an interface between soft stainless steel substrates and hard coatings to improve adhesion. This paper reports on the mechanical and corrosion properties of AlSI301 stainless steel (SS) after a duplex treatment consisting of plasma nitriding followed by deposition of Cr bond coat and CrSiN top layer by magnetron sputtering. Mechanical properties of the deposited films, such as hardness (H) and reduced Young's modulus (Er), were measured using depth-sensing indentation. Potentiodynamic polarization and electrochemical impedance spectroscopy (EIS) were carried out to evaluate resistance to localized and to general corrosion, respectively. The corrosion behavior has been correlated with the microstructure and composition of the surface layers, determined by complementary characterization techniques, including XRD, SEM, and EDS. The CrSiN layers exhibited an H value of 24 GPa, whereas the nitrided layer was shown to present a gradual increase of H from 5 GPa (in the nitrogen-free SS matrix) to almost 14 GPa at the surface. The electrochemical measurements showed that the nitriding temperature is a critical parameter for defining the corrosion properties of the duplex-treated SS. At a relatively high temperature (723 K), the nitrided layer exhibited poor corrosion resistance due to the precipitation of chromium nitride compounds and the depletion of Cr in the iron matrix. This, in turn, leads to poor corrosion performance of the duplex-treated SS since pores and defects in the CrSiN film were potential sites for pitting. At relatively low nitriding temperature (573 K), the nitrided interface exhibited excellent corrosion resistance due to the formation of a compound-free diffusion layer. This is found to favor passivation of the material at the electrode/electrolyte interface of the duplex-treated SS. (C) 2010 Elsevier B.V. All rights reserved.
引用
收藏
页码:1557 / 1563
页数:7
相关论文
共 50 条
  • [1] Structural, mechanical and tribological properties of duplex-treated AISI 5140 steel
    Alsaran, A
    Çelik, A
    Karakan, M
    [J]. MATERIALS CHARACTERIZATION, 2005, 54 (01) : 85 - 92
  • [2] Tribological properties of laser surface texturing and molybdenizing duplex-treated stainless steel at elevated temperatures
    Li, Jianliang
    Xiong, Dangsheng
    Wu, Hongyan
    Zhang, Yongkang
    Qin, Yongkun
    [J]. SURFACE & COATINGS TECHNOLOGY, 2013, 228 : S219 - S223
  • [3] EFFECT OF INTERMETALLIC PHASES ON CORROSION BEHAVIOR AND MECHANICAL PROPERTIES OF DUPLEX STAINLESS STEEL AND SUPER-DUPLEX STAINLESS STEEL
    Paulraj, Prabhu
    Garg, Rajnish
    [J]. ADVANCES IN SCIENCE AND TECHNOLOGY-RESEARCH JOURNAL, 2015, 9 (27): : 87 - 105
  • [4] Effect of microstructure on mechanical properties and corrosion resistance of 2205 duplex stainless steel
    Labanowski, Jerzy
    Swierczynska, Aleksandra
    Topolska, Santina
    [J]. POLISH MARITIME RESEARCH, 2014, 21 (04) : 108 - 112
  • [5] MECHANICAL PROPERTIES OF DUPLEX TREATED AISI 316L STAINLESS STEEL
    Joska, Zdenek
    Kadlec, Jaromir
    Hruby, Vojtech
    Svoboda, Emil
    [J]. METAL 2011: 20TH ANNIVERSARY INTERNATIONAL CONFERENCE ON METALLURGY AND MATERIALS, 2011, : 724 - 728
  • [6] Characterization and mechanical properties of a δ/γ duplex stainless steel
    Jiménez, JA
    Carsi, M
    Frommeyer, G
    Ruano, OA
    [J]. CREEP AND FRACTURE OF ENGINEERING MATERIALS AND STRUCTURES, 2000, 171-1 : 389 - 394
  • [7] Characterization and mechanical properties of a δ/γ duplex stainless steel
    Jiménez, J.A.
    Carsi, M.
    Frommeyer, G.
    Ruano, O.A.
    [J]. Key Engineering Materials, 2000, 171-174 : 389 - 394
  • [8] Mechanical properties and corrosion behaviour of duplex stainless steel weldment using novel electrodes
    Ibrahim Momoh-Bello Omiogbemi
    Danjuma Saleh Yawas
    Atanu Das
    Matthew Olatunde Afolayan
    Emmanuel Toi Dauda
    Roshan Kumar
    Sudhakar Rao Gorja
    Sandip Ghosh Chowdhury
    [J]. Scientific Reports, 12
  • [9] MECHANICAL-PROPERTIES AND CORROSION-RESISTANCE OF DUPLEX STAINLESS-STEEL WELDMENT
    KOMIZO, YI
    [J]. TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 1986, 72 (05): : S601 - S601
  • [10] Effects of the Welding Process on Mechanical Properties and Corrosion Resistance of 2205 Duplex Stainless Steel
    Ding, Lianzheng
    Meng, Qingsen
    Wang, Zhongwei
    Wang, Gang
    [J]. MANUFACTURING PROCESS TECHNOLOGY, PTS 1-5, 2011, 189-193 : 1212 - +