Evaluation of an improved input current shaper used as power factor corrector in electronic ballast

被引：0
|
作者：
Ponce, M [1 ]
Martínez, AJ [1 ]
Correa, J [1 ]
Arau, J [1 ]
机构：
[1] Ctr Nacl Invest & Desarrollo Tecnol, CENIDET, Dept Elect, Cuernavaca 62050, Morelos, Mexico
来源：
2002 IEEE INTERNATIONAL SYMPOSIUM ON CIRCUITS AND SYSTEMS, VOL IV, PROCEEDINGS | 2002年
关键词：
D O I：
暂无
中图分类号：
TP3 [计算技术、计算机技术];
学科分类号：
0812 ;
摘要：
In this paper the evaluation of an improved input current shaper used as a. single-stage power factor correction (PFC) in electronic ballast is presented. The proposed topology use two voltage sources connected in series to feed the inverter that ballasting the lamp, one of them consists in the rectified line voltage and the other is a buck-boost converter operating in DCM. On this way the buck-boost converter process a lower energy than the nominal power of the lamp. The proposed topology presents single stage, high-power-factor, low current crest factor in the lamp and high efficiency.
引用
收藏
页码：349 / 352
页数：4
相关论文
共 50 条
  • [1] Current sensorless power factor corrector applied to electronic ballast for HID lamps
    Lopez, Victor M.
    Javier Diaz, F.
    Azcondo, Francisco J.
    INTERNATIONAL EXHIBITION AND CONFERENCE FOR POWER ELECTRONICS, INTELLIGENT MOTION AND POWER QUALITY 2010 (PCIM EUROPE 2010), VOLS 1 AND 2, 2010, : 830 - 835
  • [2] Design and experimental results of an input-current-shaper based electronic ballast
    Calleja, AJ
    Alonso, JM
    Ribas, J
    Corominas, EL
    Rico-Secades, M
    Sebastián, J
    IEEE TRANSACTIONS ON POWER ELECTRONICS, 2003, 18 (02) : 547 - 557
  • [3] A Sinusoidal Input Current and High Power-Factor Based Electronic Ballast
    Sikder, Ashif Iqbal
    Islam, Kazi Saiful
    Adib, Aswad
    2012 2ND INTERNATIONAL CONFERENCE ON POWER, CONTROL AND EMBEDDED SYSTEMS (ICPCES 2012), 2012,
  • [4] Using input current shaper in the implementation of high-power-factor electronic ballasts
    Alonso, JM
    Calleja, AJ
    Ribas, J
    López, E
    Rico-Secades, M
    Sebastián, J
    APEC'99: FOURTEENTH ANNUAL APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION, CONFERENCE PROCEEDINGS, VOLS 1 & 2, 1999, : 746 - 752
  • [5] Power-mode-controlled power-factor corrector for electronic ballast
    Azcondo, FJ
    Brañas, C
    Casanueva, R
    Bracho, S
    IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, 2005, 52 (01) : 56 - 65
  • [6] A topology survey of single-stage power factor corrector with a boost type input-current-shaper
    Qiao, CM
    Smedley, KM
    IEEE TRANSACTIONS ON POWER ELECTRONICS, 2001, 16 (03) : 360 - 368
  • [7] Single-switch unity power factor electronic ballast with continuous input current
    Hassanpour, S
    Farzaneh-Fard, F
    Faroukh-payam, A
    ICEMS 2005: Proceedings of the Eighth International Conference on Electrical Machines and Systems, Vols 1-3, 2005, : 1209 - 1213
  • [8] Methods of power factor corrector input current spectrum improvement
    Rohal, V.V.
    Demchenko, Yu. S.
    Technical Electrodynamics, 2015, 2015 (06): : 29 - 33
  • [9] New continuous-input current charge pump power-factor-correction electronic ballast
    Qian, JR
    Lee, FC
    Yamauchi, T
    IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 1999, 35 (02) : 433 - 441
  • [10] Low cost high power factor electronic ballast with no input filter
    Nascimento, CB
    Perin, AJ
    Pereira, EI
    2005 IEEE 36TH POWER ELECTRONIC SPECIALISTS CONFERENCE (PESC), VOLS 1-3, 2005, : 1100 - 1106
12345