Using input current shaper in the implementation of high-power-factor electronic ballasts

被引：11

作者：

Alonso, JM ^{[1
]}

Calleja, AJ ^{[1
]}

Ribas, J ^{[1
]}

López, E ^{[1
]}

Rico-Secades, M ^{[1
]}

Sebastián, J ^{[1
]}

机构：

[1] Univ Oviedo, DIEECS Technol Elect, Gijon 33204, Spain

来源：

APEC'99: FOURTEENTH ANNUAL APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION, CONFERENCE PROCEEDINGS, VOLS 1 & 2 | 1999年

关键词：

D O I：

10.1109/APEC.1999.750444

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

In this paper a new solution to implement single-stage high-power-factor electronic ballasts based on the input current shaper (ICS) is presented, The ICS is implemented between main rectifier and bulk capacitor to increase the conduction angle of the main rectifier diodes up to a minimum value to obtain low current harmonics injected to the mains. The ICS incorporates only passive elements, avoiding the use of extra control circuitry, thus featuring low cost for the electronic ballast, Both analysis and experimental results are provided in the paper to validate the proposed topology.

引用

页码：746 / 752

页数：3

共 50 条

[1] High-Power-Factor LED Driver based on Input Current Shaper using a Flyback Converter
Pereira, G. G.
de Melo, M. F.
Dalla Costa, M. A.
Alonso, J. M.
2015 51ST IEEE INDUSTRY APPLICATIONS SOCIETY ANNUAL MEETING, 2015,
[2] A practical comparison among high-power-factor electronic ballasts with similar ideas
Seidel, AR
Bisogno, FE
Marchesan, TB
do Prado, RN
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 2005, 41 (06) : 1574 - 1583
[3] Evaluation of an improved input current shaper used as power factor corrector in electronic ballast
Ponce, M
Martínez, AJ
Correa, J
Arau, J
2002 IEEE INTERNATIONAL SYMPOSIUM ON CIRCUITS AND SYSTEMS, VOL IV, PROCEEDINGS, 2002, : 349 - 352
[4] Comparisons among electronic ballasts topologies with high power factor
do Prado, RN
Seidel, AR
Bisogno, FE
Marchezan, TB
APEC 2001: SIXTEENTH ANNUAL IEEE APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION, VOLS 1 AND 2, 2001, : 651 - 657
[5] High-Power-Factor Quasi-Resonant Flyback Converters Draw Sinusoidal Input Current
Adragna, Claudio
Gritti, Giovanni
2015 THIRTIETH ANNUAL IEEE APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION (APEC 2015), 2015, : 498 - 505
[6] Input current wave-shaping technique using inductor voltage sensing for high-power-factor flyback rectifier
Tanitteerapan, T
Mori, S
ELECTRONICS AND COMMUNICATIONS IN JAPAN PART I-COMMUNICATIONS, 2004, 87 (10): : 26 - 35
[7] PWM Strategy of a Matrix Converter for Reducing Input Current Harmonics under High-Power-Factor Loads
Yamakawa, Tomoyuki
Takeshita, Takaharu
2015 IEEE 2ND INTERNATIONAL FUTURE ENERGY ELECTRONICS CONFERENCE (IFEEC), 2015,
[8] Analysis, design, and experiments of a high-power-factor electronic ballast
Qian, JR
Lee, FC
Yamauchi, T
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 1998, 34 (03) : 616 - 624
[9] High-power-factor electronic ballast based on a single power processing stage
Có, MA
Simonetti, DSL
Vieira, JLF
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, 2000, 47 (04) : 809 - 820
[10] High-power-factor electronic ballast operating in critical conduction mode
Universidade Federal do Espirito, Santo, Vitoria, Brazil
IEEE Trans Power Electron, 1 (93-101):

← 1 2 3 4 5 →