Numerical investigations for the optimization of serrated finned-tube heat exchangers

被引：74

作者：

Lemouedda, A. ^{[1
,2
]}

Schmid, A. ^{[1
]}

Franz, E. ^{[1
]}

Breuer, M. ^{[3
]}

Delgado, A. ^{[2
]}

机构：

[1] Georg Simon Ohm Univ Appl Sci, Dept Proc Engn, D-90489 Nurnberg, Germany

[2] Univ Erlangen Nurnberg, Inst Fluid Mech, D-91056 Erlangen, Germany

[3] Helmut Schmidt Univ Hamburg, Inst Mech, Dept Fluid Mech, D-22043 Hamburg, Germany

来源：

APPLIED THERMAL ENGINEERING | 2011年 / 31卷 / 8-9期

关键词：

Heat exchangers; Heat transfer enhancement; Serrated finned-tubes; Segmented fins; Fin twisting; TRANSFER ENHANCEMENT; VORTEX GENERATORS; PERFORMANCE; CHANNEL; FLOW;

D O I：

10.1016/j.applthermaleng.2010.12.035

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

Helical serrated finned-tubes are well established in many thermal systems. This paper presents the results of numerical calculations carried out for the performance improvement of these devices. The work is divided into three main investigations conducted for Reynolds numbers between Re = 600 and 2600. The first investigation shows the effect of the fin serration, where a comparison between performances of finned tubes with and without fin serration is presented. Another main investigation is conducted on the effect of fin twisting of the outermost part of the fin on the performance of the serrated finned-tubes. Here, twisting angles considered are between beta = 0 degrees and 25 degrees. The third investigation deals with the effect of the number of fin segments per period. (c) 2011 Elsevier Ltd. All rights reserved.

引用

页码：1393 / 1401

页数：9

共 50 条

[31] Optimization of finned-tube heat exchangers for diesel exhaust waste heat recovery using CFD and CCD techniques
Hatami, M.
Jafaryar, M.
Ganji, D. D.
Gorji-Bandpy, M.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2014, 57 : 254 - 263
[32] Pareto optimization of heat transfer enhancement of finned-tube heat exchangers with delta-winglet vortex generators
Lemouedda, A.
Breuer, M.
Franz, E.
TURBULENCE, HEAT AND MASS TRANSFER 6, 2009, : 1015 - 1018
[33] Local heat transfer measurements of plate finned-tube heat exchangers by infrared thermography
Ay, HC
Jang, JY
Yeh, JN
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2002, 45 (20) : 4069 - 4078
[34] Prediction and measurement of apparent heat transfer coefficient by condensation in finned-tube heat exchangers
Bougriou, Cherif
Bessaih, Rachid
HEAT TRANSFER ENGINEERING, 2007, 28 (11) : 940 - 953
[35] Experimental study of frost growth characteristics on surface of finned-tube heat exchangers
Zhang L.
Guo X.
Xue J.
Huagong Xuebao/CIESC Journal, 2018, 69 : 186 - 192
[36] Numerical analysis of evaporation performance in a finned-tube heat exchanger
Byun, Ju-Suk
Lee, Jinho
Choi, Jun-Young
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2007, 30 (05): : 812 - 820
[37] A numerical study on the air-side heat transfer of perforated finned-tube heat exchangers with large fin pitches
Liu, Xiaoqin
Yu, Jianlin
Yan, Gang
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 100 : 199 - 207
[38] Accuracy of one-dimensional design procedures for finned-tube heat exchangers
Comini, G.
Savino, S.
APPLIED THERMAL ENGINEERING, 2009, 29 (14-15) : 2863 - 2869
[39] Thermal performance of finned-tube thermoacoustic heat exchangers in oscillatory flow conditions
Kamsanam, Wasan
Mao, Xiaoan
Jaworski, Artur J.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES, 2016, 101 : 169 - 180
[40] Experimental comparative analysis of finned-tube PCM-heat exchangers? performance
Herbinger, Florent
Groulx, Dominic
APPLIED THERMAL ENGINEERING, 2022, 211

← 1 2 3 4 5 →