Effect of Er:YAG laser etching on topography, microstructure, compressive strength, and bond strength of a universal adhesive to calcium silicate cements

Objective To evaluate the effect of Er:YAG etching on topography, microstructure, compressive strength, and shear bond strength (SBS) of All-Bond Universal adhesive to mineral trioxide aggregate-Angelus (AMTA) and Biodentine (BD). Methods and materials Sixty cylindrical specimens of each cement (AMTA and BD) in five groups were prepared and stored for 72 h. The control groups were non-etched, and four other groups were acid-etched and laser-etched with a pulse energy of 60, 80, or 100 mJ, followed by compressive strength testing. Surface micromorphology and topography were evaluated. Similar groups were bonded using All-Bond Universal with self-etch and etch-and-rinse (acid-etch) approaches, and laser-etch 60, 80, and 100 mJ, and SBS was tested. Data were analyzed using two-way and one-way ANOVA and the Bonferroni post hoc tests (alpha = 0.05). Results BD had a significantly higher compressive strength and SBS (except for laser-etch 100) compared to AMTA, regardless of the etching method (p < 0.001). Acid etching and laser etching 100 of both cements and laser etching 80 of BD alone produced a significantly lower compressive strength than that for the other groups. Contrary to BD, for AMTA, all the treatments significantly increased SBS compared to that of the self-etch group. Conclusions Etching of AMTA was needed for stronger bonding; laser etching with 60 or 80 mJ without compromising compressive strength was recommended. Etching not only did not improve bonding ability of BD, but it also negatively affected the strength of BD.