Nitrogen doping of polycrystalline 3C-SiC films grown using 1,3-disilabutane in a conventional LPCVD reactor

被引:35
|
作者
Wijesundara, MBJ [1 ]
Gao, D
Carraro, C
Howe, RT
Maboudian, R
机构
[1] Univ Calif Berkeley, Berkeley Sensor & Actuator Ctr, Dept Chem Engn, Berkeley, CA 94720 USA
[2] Univ Calif Berkeley, Berkeley Sensor & Actuator Ctr, Dept Elect Engn, Berkeley, CA 94720 USA
[3] Univ Calif Berkeley, Berkeley Sensor & Actuator Ctr, Dept Comp Sci, Berkeley, CA 94720 USA
[4] Univ Calif Berkeley, Berkeley Sensor & Actuator Ctr, Dept Mech Engn, Berkeley, CA 94720 USA
关键词
electrical characterization; microelectromechanical systems; nitrogen doping; single precursor; chemical vapor deposition; silicon carbide;
D O I
10.1016/S0022-0248(03)01573-2
中图分类号
O7 [晶体学];
学科分类号
0702 ; 070205 ; 0703 ; 080501 ;
摘要
The chemical, structural, and electrical characteristics of in situ doped SiC films grown from 1,3-disilabutane and NH3 at various growth temperatures, 650-850degreesC, are investigated by means of X-ray photoelectron spectroscopy, X-ray diffractometry, and four-point probe. The nitrogen is successfully incorporated throughout the SiC film. The doped films exhibit lower resistivities than the undoped films deposited at the same temperature, except for the films deposited at 650degreesC. As the deposition temperature increases, the electrical resistivity is shown to increase and then decrease,, peaking at 750degreesC. The resistivity of the polycrystalline SiC films is further controlled by adjusting the NH3 flow rate in the reactor. The lowest resistivity of 0.02 Omega cm is achieved for the film deposited at 800degreesC and the NH3 flow rate of 5 sccm. The post-deposition annealing is shown to further lower the film resistivity. (C) 2003 Elsevier B.V. All rights reserved.
引用
收藏
页码:18 / 25
页数:8
相关论文
共 50 条
  • [31] Distribution of paramagnetic defects in 3C-SiC epitaxial films grown by LPCVD method with alternate gas supply
    Tokai Univ, Kanagawa, Japan
    Materials Science Forum, 1998, 264-268 (pt 1): : 619 - 622
  • [32] Structural characterization of 3C-SiC films grown on Si layers wafer bonded to polycrystalline SiC substrates
    Myers, RL
    Hobart, KD
    Twigg, M
    Rao, S
    Fatemi, M
    Kub, FJ
    Saddow, SE
    SILICON CARBIDE 2004-MATERIALS, PROCESSING AND DEVICES, 2004, 815 : 145 - 148
  • [33] Fracture of polycrystalline 3C-SiC films in microelectromechanical systems
    Gao, D
    Carraro, C
    Radmilovic, V
    Howe, RT
    Maboudian, R
    JOURNAL OF MICROELECTROMECHANICAL SYSTEMS, 2004, 13 (06) : 972 - 976
  • [34] Microstructure analysis on polycrystalline 3C-SiC thin films
    Ricciardi, C
    Giorgis, F
    Fanchini, G
    Musso, S
    Ballarini, V
    Bennici, E
    Barucca, G
    Rossi, AM
    DIAMOND AND RELATED MATERIALS, 2005, 14 (3-7) : 1134 - 1137
  • [35] Optical and structural properties of polycrystalline 3C-SiC films
    Haddad-Adel, A.
    Inokuma, T.
    Kurata, Y.
    Hasegawa, S.
    APPLIED PHYSICS LETTERS, 2006, 89 (18)
  • [36] Electrical characteristics of polycrystalline 3C-SiC thin films
    Ahn, Jeong-Hak
    Chung, Gwiy-Sang
    EDM 2007: 8TH INTERNATIONAL WORKSHOP AND TUTORIALS ON ELECTRON DEVICES AND MATERIALS, 2007, : 32 - 33
  • [37] Doping of 3C-SiC by implantation of nitrogen at high temperatures
    R. Lossy
    W. Reichert
    E. Obermeier
    W. Skorupa
    Journal of Electronic Materials, 1997, 26 : 123 - 127
  • [38] Doping of 3C-SiC by implantation of nitrogen at high temperatures
    Lossy, R
    Reichert, W
    Obermeier, E
    Skorupa, W
    JOURNAL OF ELECTRONIC MATERIALS, 1997, 26 (03) : 123 - 127
  • [39] Enhanced Conductivity of 3C-SiC Nanowires by Nitrogen Doping
    Li, Shanying
    Li, Wenqi
    Zhao, Haipeng
    Du, Lingzhi
    NANOSCIENCE AND NANOTECHNOLOGY LETTERS, 2014, 6 (12) : 1091 - 1094
  • [40] Substitutional C incorporation into Si1-yCy alloys using novel carbon source, 1,3-disilabutane
    Yagi, Shuhei
    Abe, Katsuya
    Yamada, Akira
    Konagai, Makoto
    Japanese Journal of Applied Physics, Part 1: Regular Papers and Short Notes and Review Papers, 2004, 43 (7 A): : 4153 - 4154