Dynamic fragmentation and spheroidization of α phase grains during hot deformation of Ti-6Al-4V alloy

被引：9
|
作者：
Motyka, Maciej [1 ]
Sieniawski, Jan [1 ]
Ziaja, Waldemar [1 ]
Mroczka, Malwina [1 ]
Brylinski, Mateusz [1 ]
机构：
[1] Rzeszow Univ Technol, Fac Mech Engn & Aeronaut, Dept Mat Sci, Al Powstancow Warszawy 12, PL-35959 Rzeszow, Poland
来源：
INTERNATIONAL JOURNAL OF MATERIALS RESEARCH | 2018年 / 109卷 / 08期
关键词：
Two-phase titanium alloys; Hot deformation; Microstructure; Fragmentation and spheroidization of alpha phase grains; Superplasticity; LAMELLAR MICROSTRUCTURE; STATIC GLOBULARIZATION; MECHANISMS; SUPERPLASTICITY; KINETICS; WORKING;
D O I：
10.3139/146.111660
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
Development of mechanical properties of titanium alloys is usually achieved by the control of their microstructure (globular, lamellar, bimodal). Dynamic fragmentation and spheroidization of elongated alpha phase grains, formed from martensite laths, in the microstructure of Ti-6Al-4V alloy are considered in the paper. The effects of alpha phase grain spheroidization was evaluated in tensile tests over a temperature range of 800-900 degrees C and strain rate range of 10(-3) - 10(-2) s(-1). Completed spheroidization of elongated alpha phase grains and subsequent growth of equiaxed grains for all deformation modes were found. A low value of apparent activation energy for deformation was calculated - suggesting grain boundary sliding was the main deformation mechanism. The results showed good correlation with the kinetic rate equation based on the Zener-Hollomon parameter.
引用
收藏
页码：685 / 693
页数：9
相关论文
共 50 条
  • [21] Hot deformation behavior of Ti-6Al-4V alloy: Effect of initial microstructure
    Zhang, Z.X.
    Qu, S.J.
    Feng, A.H.
    Shen, J.
    Chen, D.L.
    Journal of Alloys and Compounds, 2017, 718 : 170 - 181
  • [22] ANALYSIS OF DEFORMATION AND MICROSTRUCTURAL EVOLUTION IN THE HOT FORGINGOF THE Ti-6Al-4V ALLOY
    Kukuryk, M.
    ARCHIVES OF METALLURGY AND MATERIALS, 2015, 60 (03) : 1639 - 1647
  • [23] Hot deformation behavior of Ti-6Al-4V alloy: Effect of initial microstructure
    Zhang, Z. X.
    Qu, S. J.
    Feng, A. H.
    Shen, J.
    Chen, D. L.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2017, 718 : 170 - 181
  • [24] ANALYSIS OF DEFORMATION AND MICROSTRUCTURAL EVOLUTION IN THE HOT FORGING OF THE Ti-6Al-4V ALLOY
    Kukuryk, M.
    ARCHIVES OF METALLURGY AND MATERIALS, 2015, 60 (02) : 597 - 604
  • [25] Hot deformation behavior of Ti-6Al-4V alloy with α' martensite starting microstructure
    Matsumoto, Hiroaki
    Liu, Bin
    Lee, Sang-Hak
    Li, Yunping
    Sato, Kazuhisa
    Ono, Yoshiki
    Chiba, Akihiko
    TMS 2012 141ST ANNUAL MEETING & EXHIBITION - SUPPLEMENTAL PROCEEDINGS, VOL 2: MATERIALS PROPERTIES, CHARACTERIZATION, AND MODELING, 2012, : 873 - 876
  • [26] Evolution of the α phase and microhardness for hot isostatic pressed Ti-6Al-4V alloy during multi-pass deformation
    Liu, Haijun
    Zhang, Zhimin
    Xu, Kaihua
    Zhang, Jishi
    Xue, Yong
    Wang, Qiang
    MATERIALS CHARACTERIZATION, 2021, 178
  • [27] CORRELATION OF DATA ON HOT DEFORMATION OF TI-6AL-4V
    BRYANT, WA
    JOURNAL OF MATERIALS SCIENCE, 1975, 10 (10) : 1793 - 1797
  • [28] Microstructure evolution of Ti-6Al-4V alloy during superplastic deformation
    Wang, Min
    Lin, Chengxiao
    Wang, M. (wangmin@nwpu.edu.cn), 1600, Science Press (41): : 1176 - 1180
  • [29] Microstructure Evolution of Ti-6Al-4V Alloy during Superplastic Deformation
    Wang Min
    Lin Chengxiao
    RARE METAL MATERIALS AND ENGINEERING, 2012, 41 (07) : 1176 - 1180
  • [30] Strong and Ductile Ti-6Al-4V Alloy Produced by Hot Pressing of Ti-6Al-4V Swarf
    Yang, F.
    Pi, Z. Q.
    Zhao, Q. Y.
    Raynova, S.
    Liu, Q.
    Sharp, K.
    Brandt, M.
    Bolzoni, L.
    Qian, M.
    JOM, 2019, 71 (03) : 1056 - 1061
12345