Dynamic fragmentation and spheroidization of α phase grains during hot deformation of Ti-6Al-4V alloy

被引：9

作者：

Motyka, Maciej ^{[1
]}

Sieniawski, Jan ^{[1
]}

Ziaja, Waldemar ^{[1
]}

Mroczka, Malwina ^{[1
]}

Brylinski, Mateusz ^{[1
]}

机构：

[1] Rzeszow Univ Technol, Fac Mech Engn & Aeronaut, Dept Mat Sci, Al Powstancow Warszawy 12, PL-35959 Rzeszow, Poland

来源：

INTERNATIONAL JOURNAL OF MATERIALS RESEARCH | 2018年 / 109卷 / 08期

关键词：

Two-phase titanium alloys; Hot deformation; Microstructure; Fragmentation and spheroidization of alpha phase grains; Superplasticity; LAMELLAR MICROSTRUCTURE; STATIC GLOBULARIZATION; MECHANISMS; SUPERPLASTICITY; KINETICS; WORKING;

D O I：

10.3139/146.111660

中图分类号：

TF [冶金工业];

学科分类号：

0806 ;

摘要：

Development of mechanical properties of titanium alloys is usually achieved by the control of their microstructure (globular, lamellar, bimodal). Dynamic fragmentation and spheroidization of elongated alpha phase grains, formed from martensite laths, in the microstructure of Ti-6Al-4V alloy are considered in the paper. The effects of alpha phase grain spheroidization was evaluated in tensile tests over a temperature range of 800-900 degrees C and strain rate range of 10(-3) - 10(-2) s(-1). Completed spheroidization of elongated alpha phase grains and subsequent growth of equiaxed grains for all deformation modes were found. A low value of apparent activation energy for deformation was calculated - suggesting grain boundary sliding was the main deformation mechanism. The results showed good correlation with the kinetic rate equation based on the Zener-Hollomon parameter.

引用

页码：685 / 693

页数：9

共 50 条

[1] Effect of strain reversal on the dynamic spheroidization of Ti-6Al-4V during hot deformation
R. M. Poths
B. P. Wynne
W. M. Rainforth
J. H. Beynon
G. Angella
S. L. Semiatin
Metallurgical and Materials Transactions A, 2004, 35 : 2993 - 3001
[2] Spheroidization of the lamellar microstructure in Ti-6Al-4V alloy during warm deformation and annealing
Zherebtsov, S.
Murzinova, M.
Salishchev, A.
Sennatin, S. L.
ACTA MATERIALIA, 2011, 59 (10) : 4138 - 4150
[3] A New Method to Increase the Spheroidization Rate of LamellarαMicrostructure during Hot Deformation of a Ti-6Al-4V Alloy
Jiang, Yu-Qiang
Lin, Y. C.
Zhao, Chun-Yang
Chen, Ming-Song
He, Dao-Guang
ADVANCED ENGINEERING MATERIALS, 2020, 22 (10)
[4] Dynamic Recrystallization of Ti-6Al-4V Alloy During Hot Compression
Liu C.
Wang X.
Men Y.
Zhang H.
Zhang S.
Zhou G.
Chen L.
Liu H.
Cailiao Yanjiu Xuebao/Chinese Journal of Materials Research, 2021, 35 (08): : 583 - 590
[5] The evolution of microstructure of Ti-6Al-4V alloy during concurrent hot deformation and phase transformation
He, Lijia
Dehghan-Manshadi, A.
Dippenaar, R. J.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2012, 549 : 163 - 167
[6] Effect of Hydrogenation on the Hot Deformation of Ti-6Al-4V Alloy
Niu Yong
Li Xiaohua
Wang Yaoqi
Hou Hongliang
Li Miaoquan
Lin Yingying
Li Zhiqiang
RARE METAL MATERIALS AND ENGINEERING, 2008, 37 (12) : 2089 - 2093
[7] Effect of hydrogenation on the hot deformation of Ti-6Al-4V alloy
Northwestern Polytechnical University, Xi'an 710072, China
不详
Xiyou Jinshu Cailiao Yu Gongcheng, 2008, 12 (2089-2093):
[8] Hot deformation behavior and dynamic recrystallization of melt hydrogenated Ti-6Al-4V alloy
Wang, Xuan
Wang, Liang
Luo, LiangShun
Liu, XiaoDong
Tang, YingChun
Li, XinZhong
Chen, RuiRun
Su, YanQing
Guo, JingJie
Fu, HengZhi
JOURNAL OF ALLOYS AND COMPOUNDS, 2017, 728 : 709 - 718
[9] Microstructural evolution in Ti-6Al-4V during hot deformation
Gartside, MB
ADVANCES IN THE SCIENCE AND TECHNOLOGY OF TITANIUM ALLOY PROCESSING, 1996, : 101 - 108
[10] Effect of hot deformation on the tribological behaviour of Ti-6Al-4V alloy
Ismail, A.
Abdel-Aziz, M.
El-Morsy, A.
El-Bitar, T.
CANADIAN METALLURGICAL QUARTERLY, 2006, 45 (04) : 469 - 473

← 1 2 3 4 5 →