Low-temperature synthesis of lanthanum strontium cobalt ferrite by the citrate complex method adding oleic acid

被引:5
|
作者
Mimuro, Shin [1 ,2 ]
Makinose, Yuki [1 ]
Matsushita, Nobuhiro [1 ]
机构
[1] Tokyo Inst Technol, Mat & Struct Lab, Midori Ku, Yokohama, Kanagawa 2268503, Japan
[2] Nissan Motor Co Ltd, Nissan Res Ctr, EV Syst Lab, Yokosuka, Kanagawa 2268523, Japan
关键词
Lanthanum strontium cobalt ferrite; Low-temperature synthesis; Citrate complex method; Oleic acid; Surfactant; OXIDE FUEL-CELLS; LSCF; DIFFRACTION; PERFORMANCE; CATHODES;
D O I
10.1016/j.apt.2015.06.006
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
Crystalline lanthanum strontium cobalt ferrite (LSCF) was obtained by calcination at a low temperature of 500 degrees C from precursor nanoparticles. The precursor nanoparticles were synthesized by the citrate complex method adding oleic acid as a surfactant, and dynamic laser scattering measurements suggested that they exhibited high dispersibility in the solution with an average diameter less than around 20 nm. The crystallite size decreased and the total specific area increased as the calcination temperature was decreased from 800 to 500 degrees C. It was found that the oleic acid functioned as a surfactant to form homogeneous fine precursor, and then assisted in the crystallization of LSCF even at a low calcination temperature of 500 degrees C. Such a low temperature synthesis suppressed the agglomeration and growth of LSCF particles so that fine powders with particle size less than 20 nm were obtained. (C) 2015 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.
引用
收藏
页码:1245 / 1249
页数:5
相关论文
共 50 条
  • [31] LOW-TEMPERATURE SYNTHESIS AND CHARACTERIZATION OF SPINEL FERRITE POWDERS
    Bushkova, V. S.
    Ostafiychuk, B. K.
    POWDER METALLURGY AND METAL CERAMICS, 2016, 54 (9-10) : 509 - 516
  • [32] Low-temperature synthesis and characterization of the Mn–Zn ferrite
    Irena Szczygiel
    Katarzyna Winiarska
    Journal of Thermal Analysis and Calorimetry, 2011, 104 : 577 - 583
  • [33] A novel low-temperature synthesis of nanosized NiZn ferrite
    Verma, S
    Pradhan, SD
    Pasricha, R
    Sainkar, SR
    Joy, PA
    JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2005, 88 (09) : 2597 - 2599
  • [34] Low-temperature deep oxidation of olefins and DME over cobalt ferrite
    Tian, Zhen-Yu
    Kouotou, Patrick Mountapmbeme
    El Kasmi, Achraf
    Ngamou, Patrick Herve Tchoua
    Kohse-Hoeinghaus, Katharina
    Vieker, Henning
    Beyer, Andre
    Goelzhaeuser, Armin
    PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2015, 35 : 2207 - 2214
  • [35] A new low-temperature sintering method for NiCuZn ferrite
    Bian, Pei
    Ju, Dong-Ying
    HIGH-PERFORMANCE CERAMICS IV, PTS 1-3, 2007, 336-338 : 695 - +
  • [36] Low-temperature sintering of lanthanum strontium manganite-based contact pastes for SOFCs
    McCarthy, B. P.
    Pederson, L. R.
    Chou, Y. S.
    Zhou, X.-D.
    Surdoval, W. A.
    Wilson, L. C.
    JOURNAL OF POWER SOURCES, 2008, 180 (01) : 294 - 300
  • [37] Electrical Properties of the Lanthanum Ferrite-Based Cathode Materials for Low-Temperature SOFCs
    Kang, Ju Hyun
    Choi, Jung Woon
    Shim, Han Byel
    Yoo, Kwang Soo
    JOURNAL OF THE KOREAN CERAMIC SOCIETY, 2006, 43 (03) : 162 - 168
  • [38] The synthesis of cobalt nanoparticles by solution combustion synthesis method in a new reactor at low-temperature conditions
    Barati, M. D.
    Khoshandam, B.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART N-JOURNAL OF NANOMATERIALS NANOENGINEERING AND NANOSYSTEMS, 2023,
  • [39] Low-Temperature Hydrothermal Synthesis of Ultrafine Strontium Hexaferrite Nanoparticles
    Primc, Darinka
    Drofenik, Miha
    Makovec, Darko
    EUROPEAN JOURNAL OF INORGANIC CHEMISTRY, 2011, (25) : 3802 - 3809
  • [40] Low Temperature Lanthanum Strontium Ferrite Thin Film Stress and Oxygen Surface Exchange Coefficient Measurements
    Yang, Qing
    Lunt, Richard R.
    Nicholas, Jason D.
    HIGH TEMPERATURE EXPERIMENTAL TECHNIQUES AND MEASUREMENTS, 2013, 58 (03): : 37 - 46