Performance analysis of open-source DEMs in tsunami inundation modelling

被引:3
|
作者
Tufekci-Enginar, Duygu [1 ]
Dogan, Gozde Guney [2 ]
Suzen, Mehmet Lutfi [1 ]
Yalciner, Ahmet Cevdet [2 ]
机构
[1] Middle East Tech Univ, Dept Geol Engn, Ankara, Turkey
[2] Middle East Tech Univ, Dept Civil Engn, Ankara, Turkey
关键词
Global DEM; LiDAR; Tsunami modeling; Inundation; Flow depth; DIGITAL ELEVATION MODELS; ACCURACY ASSESSMENT; VERTICAL ACCURACY; ASTER GDEM; RESOLUTION; ALOS; SRTM; VULNERABILITY; LANDSLIDE; SEA;
D O I
10.1007/s12145-022-00852-1
中图分类号
TP39 [计算机的应用];
学科分类号
081203 ; 0835 ;
摘要
In natural hazard modeling, underestimation is not acceptable, since it will produce unreliable and inadequate information for decision makers to work on during hazard mitigation planning. Including tsunami inundation modeling, result of the natural hazard models is highly sensitive to the accuracy of input data. High resolution elevation data, such as light detection and ranging (LiDAR) Digital Elevation Models (DEMs) can provide modeling results that are closer to the reality. However, gathering such high-resolution datasets is expensive, time consuming and is usually not open to public access. Moreover, required computational time with those high-resolution datasets is significantly long. Therefore, open-source DEMs such as, Advanced Land Observing Satellite (ALOS) World 3D (AW3D30), Advanced Spaceborne Thermal Emission and Reflection Radiometer Global Digital Elevation Model (ASTER GDEM) and Shuttle Radar Topography Mission (SRTM) are usually the first preferred data sets. This study aims to analyse the performances of AW3D30, ASTER GDEM, and SRTM for tsunami modeling by comparing them with high-resolution LiDAR DEM tsunami modeling results. For the selected test site of this study, among these three open-source DEMs, tsunami simulations performed with ASTER GDEM exhibits an underestimated coverage of tsunami inundation areas and the maximum flow depth values in those areas and should not be preferred. Whereas, the comparisons of the simulation results using SRTM and AW3D30 as input DEMs revealed that, inundated areas are not less than the LiDAR reference and their error is lower at land use based flow depth analysis. Therefore, AW3D30 and SRTM can be accepted to use in tsunami modeling for the test site of this study considering their limited accuracy and low resolutions, when there is no available higher resolution data with good accuracy or if a rapid hazard assessment is required. However, it should be noted that open-source DEMs may have substantial errors or inadequacy on other coastal areas with different settings. Therefore, it is advised to be cautious in the usage of open-source DEMs in tsunami inundation modeling.
引用
收藏
页码:2447 / 2466
页数:20
相关论文
共 50 条
  • [31] On the Performance of Open-Source RTOS Synchronization Primitives
    Bertolotti, Ivan Cibrario
    Kashani, Gilda Ghafour Zadeh
    2015 IEEE 1ST INTERNATIONAL FORUM ON RESEARCH AND TECHNOLOGIES FOR SOCIETY AND INDUSTRY (RTSI 2015) PROCEEDINGS, 2015,
  • [32] Evaluating the Performance Open-Source Vulnerability Scanners
    Gajula, Mohammad Rafi
    Vassilakis, Vassilios G.
    2024 14TH INTERNATIONAL SYMPOSIUM ON COMMUNICATION SYSTEMS, NETWORKS AND DIGITAL SIGNAL PROCESSING, CSNDSP 2024, 2024, : 377 - 382
  • [33] A new generation of tsunami inundation maps of Chilean cities: tsunami source database and probabilistic hazard analysis
    Aranguiz, Rafael
    Ramos, Marilym
    Sepulveda, Ignacio
    Villagra, Paula
    COASTAL ENGINEERING JOURNAL, 2024, 66 (02) : 361 - 379
  • [34] The Uranie platform: an open-source software for optimisation, meta-modelling and uncertainty analysis
    Blanchard, Jean-Baptiste
    Damblin, Guillaume
    Martinez, Jean-Marc
    Arnaud, Gilles
    Gaudier, Fabrice
    EPJ NUCLEAR SCIENCES & TECHNOLOGIES, 2019, 5
  • [35] Inundation Modelling of the December 2004 Indian Ocean Tsunami
    Jakeman, J. D.
    Bartzis, N.
    Nielsen, O.
    Roberts, S.
    MODSIM 2007: INTERNATIONAL CONGRESS ON MODELLING AND SIMULATION: LAND, WATER AND ENVIRONMENTAL MANAGEMENT: INTEGRATED SYSTEMS FOR SUSTAINABILITY, 2007, : 1667 - 1673
  • [36] Open-source modelling infrastructure: Building decarbonization capacity in Canada
    McPherson, Madeleine
    Monroe, Jacob
    Jurasz, Jakub
    Rowe, Andrew
    Hendriks, Richard
    Stanislaw, Lauren
    Awais, Muhammad
    Seatle, Madeleine
    Xu, Robert
    Crownshaw, Timothy
    Miri, Mohammad
    Aldana, Dustin
    Esfahlani, Moe
    Arjmand, Reza
    Saffari, Mohammadali
    Cusi, Tristan
    Toor, Kanwarpreet Singh
    Grieco, Joel
    ENERGY STRATEGY REVIEWS, 2022, 44
  • [37] Development of a Hydraulic Modelling Platform Within an Open-Source Environment
    Duran, Camille
    Lepelletier, Thierry
    Mora, Vincent
    ADVANCES IN HYDROINFORMATICS: SIMHYDRO 2017 - CHOOSING THE RIGHT MODEL IN APPLIED HYDRAULICS, 2018, : 105 - 115
  • [38] SpineOpt: A flexible open-source energy system modelling framework
    Ihlemann, Maren
    Kouveliotis-Lysikatos, Iasonas
    Huang, Jiangyi
    Dillon, Joseph
    O'Dwyer, Ciara
    Rasku, Topi
    Marin, Manuel
    Poncelet, Kris
    Kiviluoma, Juha
    ENERGY STRATEGY REVIEWS, 2022, 43
  • [39] AN INVESTIGATION INTO OPEN-SOURCE MODELLING IN HEALTH ECONOMICS: OPPORTUNITIES AND CHALLENGES
    Mason, N.
    Kenworthy, J. J.
    Akehurst, R.
    Sullivan, W.
    Dunlop, W.
    VALUE IN HEALTH, 2016, 19 (07) : A369 - A369
  • [40] OpenSYMORO: An open-source software package for Symbolic Modelling of Robots
    Khalil, Wisama
    Vijayalingam, Aravindkumar
    Khomutenko, Bogdan
    Mukhanov, Izzatbek
    Lemoine, Philippe
    Ecorchard, Gael
    2014 IEEE/ASME INTERNATIONAL CONFERENCE ON ADVANCED INTELLIGENT MECHATRONICS (AIM), 2014, : 1206 - 1211