共 50 条
Source apportionment of the ambient PM2.5 across St. Louis using constrained positive matrix factorization
被引:129
|作者:
Amato, Fulvio
[2
,3
]
Hopke, Philip K.
[1
]
机构:
[1] Clarkson Univ, Ctr Air Resources Engn & Sci, Potsdam, NY 13699 USA
[2] Spanish Res Council CSIC, IDAEA, Inst Environm Assessment & Water Res, Barcelona 08034, Spain
[3] TNO Environm & Geosci, Dept Climate Air & Sustainabil, NL-3508 TA Utrecht, Netherlands
关键词:
Multilinear Engine;
PMF;
Target Transformation;
Rotational control;
Physical constraints;
CPF;
RESOLVED CARBON FRACTIONS;
FACTOR-ANALYTIC MODELS;
SOURCE IDENTIFICATION;
ELEMENTAL CARBON;
FINE PARTICLES;
AEROSOL;
TRANSMITTANCE;
D O I:
10.1016/j.atmosenv.2011.09.062
中图分类号:
X [环境科学、安全科学];
学科分类号:
08 ;
0830 ;
摘要:
In most cases, receptor models are applied to data from a single monitoring site even if there are multiple sampling locations in a given urban area. When it can be reasonably expected that the sites are affected by the same set of sources, it is possible to use the spatial variability of the source contributions to enhance the source apportionment. With the framework of positive matrix factorization, it is possible to enhance the results through an effective use of multiple site data. There have been several previous studies of the sources of ambient PM2.5 in St Louis, MO based on data from the US EPA chemical speciation network and the St Louis-Midwest Supersite. However, these different analyses identified different sets of sources including the omission of known major emission sources. A re-examination of the previous studies was undertaken using knowledge of the existing sources based on independent data and the resulting profiles were used to constrain the solution. These new solutions provide more realistic results in which the source impacts of all of the major sources could be assessed at each site. (C) 2011 Elsevier Ltd. All rights reserved.
引用
收藏
页码:329 / 337
页数:9
相关论文