Modelling of cyclic plasticity and martensitic transformation for type 304 austenitic stainless steel

被引：21

作者：

Hamasaki, Hiroshi ^{[1
]}

Ohno, Tatsuya ^{[1
]}

Nakano, Takashi ^{[1
]}

Ishimaru, Eiichiro ^{[2
]}

机构：

[1] Hiroshima Univ, Dept Mech Sci & Engn, 1-4-1 Kagamiyama, Higashihiroshima, Hiroshima 7398527, Japan

[2] Nippon Steel & Sumikin Stainless Steel Corp, 3434 Shimata, Yamaguchi 7438550, Japan

来源：

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES | 2018年 / 146卷

基金：

日本学术振兴会;

关键词：

Stainless steel; Martensitic transformation; Cyclic plasticity; Constitutive equation; DEFORMATION-INDUCED TRANSFORMATION; STRAIN-RATE; MECHANICAL-BEHAVIOR; CONSTITUTIVE MODEL; KINETICS; STATE;

D O I：

10.1016/j.ijmecsci.2017.12.003

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Isothermal monotonic tension and cyclic tests are conducted on type 304 austenitic stainless steel at 20, 50 and 80 degrees C from which stress-strain curves and martensite volume fraction were evaluated. The obtained data showed that deformation induced martensitic transformation was highly temperature dependent in monotonic tensile and cyclic tests. In cyclic test, stagnation of martensitic transformation was observed during the Bauschinger region, which imply that the transformation was triggered by austenite stress rather than the plastic strain. Finally, constitutive model based on stress induced hypothesis was proposed and it was validated by comparing the experimental results and the calculation with the conventional Stringfellow model. (C) 2017 Elsevier Ltd. All rights reserved.

引用

页码：536 / 543

页数：8

共 50 条

[41] STRAIN-INDUCED MARTENSITIC TRANSFORMATION IN 304L AUSTENITIC STAINLESS STEEL UNDER ECAP DEFORMATION
Yang Gang
Huang Chongxiang
Wu Shiding
Zhang Zhefeng
ACTA METALLURGICA SINICA, 2009, 45 (08) : 906 - 911
[42] Numerical and Experimental Analysis of Damage Evolution and Martensitic Transformation in AISI 304 Austenitic Stainless Steel at Cryogenic Temperature
Kazemi, Seyed Saied
Homayounfard, Milad
Ganjiani, Mehdi
Soltani, Naser
INTERNATIONAL JOURNAL OF APPLIED MECHANICS, 2019, 11 (02)
[43] CMT Butt Welding Mechanism of M390 Martensitic Stainless Steel and 304 Austenitic Stainless Steel
Qiao L.
Cao R.
Che H.
Li S.
Wang T.
Dong H.
Wang C.
Yan Y.
Cailiao Daobao/Materials Reports, 2023, 37 (07):
[44] Effect of strain-induced martensitic transformation on fatigue behavior of type 304 stainless steel
Nakajima, M.
Akita, M.
Uematsu, Y.
Tokaji, K.
FATIGUE 2010, 2010, 2 (01): : 323 - 330
[45] MECHANISM OF AUSTENITIC TRANSFORMATION IN THE MARTENSITIC STAINLESS-STEEL OF TYPE PH-15-5
BAJGUIRANI, HRH
JOURNAL DE PHYSIQUE IV, 1994, 4 (C3): : 123 - 126
[46] Deformation-induced phase transformation and strain hardening in type 304 austenitic stainless steel
Amar K. De
John G. Speer
David K. Matlock
David C. Murdock
Martin C. Mataya
Robert J. Comstock
Metallurgical and Materials Transactions A, 2006, 37 : 1875 - 1886
[47] Deformation-induced phase transformation and strain hardening in type 304 austenitic stainless steel
De, Amar K.
Speer, John G.
Matlock, David K.
Murdock, David C.
Mataya, Martin C.
Comstock, Robert J., Jr.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2006, 37A (06): : 1875 - 1886
[48] THE PROPAGATION VELOCITY OF THE MARTENSITIC-TRANSFORMATION IN 304 STAINLESS-STEEL
TAKASHIMA, K
HIGO, Y
NUNOMURA, S
PHILOSOPHICAL MAGAZINE A-PHYSICS OF CONDENSED MATTER STRUCTURE DEFECTS AND MECHANICAL PROPERTIES, 1984, 49 (02): : 231 - 241
[49] Deformation induced martensitic transformation in a 201 modified austenitic stainless steel
Tavares, S. S. M.
Pardal, J. M.
Gomes da Silva, M. J.
Abreu, H. F. G.
da Silva, M. R.
MATERIALS CHARACTERIZATION, 2009, 60 (08) : 907 - 911
[50] Experimental investigation on martensitic transformation and fracture morphologies of austenitic stainless steel
Das, Arpan
Tarafder, Soumitra
INTERNATIONAL JOURNAL OF PLASTICITY, 2009, 25 (11) : 2222 - 2247

← 1 2 3 4 5 →