Numerical investigation of heat transfer from a plane surface due to turbulent annular swirling jet impingement

被引:33
|
作者
Afroz, Farhana [1 ]
Sharif, Muhammad A. R. [1 ]
机构
[1] Univ Alabama, Aerosp Engn & Mech Dept, Tuscaloosa, AL 35487 USA
关键词
Annular turbulent jet; Impinging jet; Swirling jet; Reverse stagnation; IMPINGING JET; FLOW STRUCTURE; MASS-TRANSFER; PRESSURE; REGION; GAS;
D O I
10.1016/j.ijthermalsci.2019.106257
中图分类号
O414.1 [热力学];
学科分类号
摘要
The heat transfer characteristic of an annular turbulent swirling jet impingement on a heated plane surface is investigated numerically. The annular jet configuration causes instabilities and fluctuations in the flow. Depending on the combinations of different parameters, the annular jet impingement may have positive or negative effects on the heat transfer from the impingement surface. Swirl, on the other hand, introduces vorticity and fluid mixing in an impinging jet, which is desirable in some applications. The axisymmetric two-dimensional flow domain on a radial-axial plane is considered in the numerical model. Both non-swirling and swirling jet impingement is studied. The numerical computations are performed using the ANSYS Fluent CFD code. The Realizable k-epsilon turbulence model with enhanced wall treatment is used in the computation. The computational process is validated against other published data on similar flow configuration for non-swirling annular impinging jets. The flow and geometric parameters are the jet exit Reynolds number, Re (5000 to 25,000), the swirl strength Sw (0-0.77), the jet exit to the impingement surface distance, H (0.5-4.0), and the moderate blockage ratio of the annular jet, BR (0.4-0.6). The thermal-hydraulic field in the domain is computed for various combinations of these parameters. The effects of these parameters on the Nusselt number distribution on the impingement surface are analyzed. For short separation distance (H = 0.5), the swirling motion positively affects the overall heat transfer, and the average Nu is increased as high as 8% for certain combinations of Re, Sw, and BR; compared to the non-swirling annular jet impingement. For higher separation distances, the average and peak Nusselt number is initially reduced and then increased with increasing swirl strength.
引用
收藏
页数:14
相关论文
共 50 条
  • [31] Enhancement of an impingement heat transfer between turbulent mist jet and flat surface
    Pakhomov, M. A.
    Terekhov, V. I.
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2010, 53 (15-16) : 3156 - 3165
  • [32] Numerical thermal analysis of water's boiling heat transfer based on a turbulent jet impingement on heated surface
    Toghraie, D.
    PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES, 2016, 84 : 454 - 465
  • [33] Experimental Analysis of Heat Transfer and Multi Objective Optimization of Swirling Jet Impingement on a Flat Surface
    Illyasi, S. Mohamed
    Bapu, B. R. Ramesh
    Rao, V. Venkata Subba
    JOURNAL OF APPLIED FLUID MECHANICS, 2019, 12 (03) : 803 - 817
  • [34] Numerical analysis of turbulent round jet impingement heat transfer at high temperature difference
    Zhou, Taotao
    Xu, Dong
    Chen, Jing
    Cao, Changmin
    Ye, Taohong
    APPLIED THERMAL ENGINEERING, 2016, 100 : 55 - 61
  • [35] Numerical investigation on hybrid-linked jet impingement heat transfer based on the response surface methodology
    Yang, Li
    Min, Zheng
    Sarwesh, Parbat Narayan
    Chyu, Minking K.
    NUMERICAL HEAT TRANSFER PART A-APPLICATIONS, 2016, 70 (12) : 1297 - 1312
  • [36] Convective Heat Transfer at an Annular Jet Impingement on a Flat Blockage
    Terekhov, V. I.
    Kalinina, S. V.
    Sharov, K. A.
    HIGH TEMPERATURE, 2018, 56 (02) : 217 - 222
  • [37] Convective Heat Transfer at an Annular Jet Impingement on a Flat Blockage
    V. I. Terekhov
    S. V. Kalinina
    K. A. Sharov
    High Temperature, 2018, 56 : 217 - 222
  • [38] Heat transfer from an inflow-type swirling turbulent impinging jet
    Ichimiya, Koichi
    Tsukamoto, Koji
    JSME INTERNATIONAL JOURNAL SERIES B-FLUIDS AND THERMAL ENGINEERING, 2006, 49 (04) : 995 - 999
  • [39] Numerical Analysis of Heat Transfer from a Moving Surface Due to Impingement of Slot Jets
    Kadiyala, Phani Krishna
    Chattopadhyay, Himadri
    HEAT TRANSFER ENGINEERING, 2018, 39 (02) : 98 - 106
  • [40] Heat transfer investigation with multiple jet impingement
    Murthy N.
    Naveenkumar B.K.
    Murthy, Niranjan (niranjanmurthy6808@gmail.com), 1600, MechAero Found. for Techn. Res. and Educ. Excellence (12): : 303 - 305