Magnetic properties of Sm-Fe-N thick film magnets prepared by the aerosol deposition method

被引：42
|
作者：
Sugimoto, S [1 ]
Maeda, T
Kobayashi, R
Akedo, J
Lebedev, M
Inomata, K
机构：
[1] Tohoku Univ, Grad Sch Engn, Dept Mat Sci, Sendai, Miyagi 9808579, Japan
[2] Natl Inst Adv Ind Sci & Technol, Ibaraki 3058564, Japan
来源：
IEEE TRANSACTIONS ON MAGNETICS | 2003年 / 39卷 / 05期
关键词：
aerosol deposition method (ADM); coercivity; high deposition rate; Sm-Fe-N film;
D O I：
10.1109/TMAG.2003.816715
中图分类号：
TM [电工技术]; TN [电子技术、通信技术];
学科分类号：
0808 ; 0809 ;
摘要：
This paper describes magnetic properties of Sm-Fe-N films prepared by an aerosol deposition method. The films with thickness of 3-45 mum were obtained by the deposition within 10 min and the deposition rate was estimated as approximately 2-10 mum/min. The Sm-Fe-N films showed relatively high micro Vickers hardness in the range from 500 to 700. The remanence of the Sm-Fe-N films was approximately 0.4 T, which was lower than that of initial host powders. However, almost of all samples showed higher coercivities around 1.8 T.
引用
收藏
页码：2986 / 2988
页数：3
相关论文
共 50 条
  • [1] Sm-Fe-N thick film magnets fabricated by aerosol deposition method
    Sugimoto, S.
    Maki, T.
    Kagotani, T.
    Inomata, K.
    Akedo, J.
    Transactions of the Materials Research Society of Japan, Vol 30, No 4, 2005, 30 (04): : 1001 - 1004
  • [2] Microstructures and magnetic properties of Sm-Fe-N thick films produced by the aerosol deposition method
    Maki, T
    Sugimoto, S
    Kagotani, T
    Inomata, K
    Akedo, J
    MATERIALS TRANSACTIONS, 2004, 45 (02) : 369 - 372
  • [3] Effect of applied magnetic field on magnetic properties of Sm-Fe-N films prepared by aerosol deposition method
    Maki, T
    Sugimoto, S
    Kagotani, T
    Inomata, K
    Akedo, J
    MATERIALS TRANSACTIONS, 2004, 45 (08) : 2626 - 2629
  • [4] Influence of deposition angle on the magnetic properties of Sm-Fe-N films fabricated by aerosol deposition method
    Maki, T
    Sugimoto, S
    Kagotani, T
    Inomata, K
    Akedo, J
    Ishikawa, T
    Ohmori, K
    JOURNAL OF ALLOYS AND COMPOUNDS, 2006, 408 : 1409 - 1412
  • [5] Influence of deposition angle on the magnetic properties of Sm-Fe-N films fabricated by aerosol deposition method
    Maki, Tomohito
    Sugimoto, Satoshi
    Kagotani, Toshio
    Inomata, Koichiro
    Akedo, Jun
    Ishikawa, Takashi
    Ohmori, Kenji
    Journal of Alloys and Compounds, 1600, 408-412 : 1409 - 1412
  • [6] Microstructure and magnetic properties of aerosol-deposited Sm-Fe-N thick films
    Maki, Tomohito
    Sugimoto, Satoshi
    Kagotani, Toshio
    Inomata, Koichiro
    Akedo, Jun
    Electrical Engineering in Japan (English translation of Denki Gakkai Ronbunshi), 2007, 158 (01): : 8 - 13
  • [7] Microstructure and magnetic properties of aerosol-deposited Sm-Fe-N thick films
    Maki, Tomohito
    Sugimoto, Satoshi
    Kagotani, Toshio
    Inomata, Koichiro
    Akedo, Jun
    ELECTRICAL ENGINEERING IN JAPAN, 2007, 158 (01) : 8 - 13
  • [8] STRUCTURAL AND MAGNETIC-PROPERTIES OF SM-FE-N MAGNETS PREPARED BY HYDROGENATION AND NITROGENATION PROCESSES
    ZHAO, XG
    ZHANG, ZD
    LIU, W
    XIAO, QF
    SUN, XK
    JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 1995, 148 (03) : 419 - 425
  • [9] Magnetic properties of isotropic Sm-Fe-N magnets produced by compression shearing method
    Saito, Tetsuji
    Kitazima, Hiroshi
    JOURNAL OF APPLIED PHYSICS, 2012, 111 (07)
  • [10] Magnetic properties of Sm-Fe-N bulk magnets produced by compression shearing method
    Saito, Tetsuji
    Sato, Hisanobu
    Fukui, Masato
    Takeishi, Hiroyuku
    Journal of Applied Physics, 2006, 99 (08):
12345