Development of a dielectric loaded RF cavity for a muon accelerator

The building of a muon collider is motivated by the desire to collide point-like particles while reducing the limitations imposed by synchrotron radiation The many challenges unique to muon accelerators are derived from the short lifetime of the muons The muons must be produced then formed into a beam and accelerated to their final energy in less than a few milliseconds in the lab frame One idea for accomplishing this is called a helical cooling channel and requires placing the accelerating structure in a solenoid The RF (radio frequency) accelerating structure in a muon accelerator should be short in the longitudinal direction small enough in the transverse direction to fit inside the solenoids of the helical cooling channel and have the highest possible electric field gradient A RF cavity that meets these requirements is crucial to the development of a muon collider There is an additional constraint if an existing source of RF power is to be used as the frequency of the lowest RF cavity mode should match the frequency of the power source At Fermilab the klystrons produce RF power at 800 MHz The resonant frequency of an RF cavity depends inversely on the radius of the cavity as well as the dielectric constant of the material within the cavity A standard vacuum cavity with a resonant frequency of 800 MHz is too large to fit within the solenoids This paper studies one method of avoiding this limitation by placing a dielectric material within the cavity The effect of this dielectric is modeled in Microwave Studio to determine the right size and shape for the dielectric given and several prototype cavities are built and tested with a network analyzer Our proof of concept experiment shows the feasibility of further developing the design of dielectric loaded RF cavities Further work will include tests at high power to determine the effects of a high electric field on the dielectric (C) 2010 Elsevier B V All rights reserved