Heat removal capacity of laminar coolant flow in a micro channel heat sink with different pin fins

被引：45

作者：

Yang, Dawei ^{[1
]}

Jin, Zhiyu ^{[1
]}

Wang, Yan ^{[1
]}

Ding, Guifu ^{[1
]}

Wang, Guilian ^{[1
,2
]}

机构：

[1] Shanghai Jiao Tong Univ, Sch Elect Informat & Elect Engn, Shanghai 200240, Peoples R China

[2] Shanghai Univ Engn Sci, Sch Elect & Elect Engn, 333 Longteng Rd, Shanghai 201620, Peoples R China

来源：

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER | 2017年 / 113卷

基金：

中国国家自然科学基金;

关键词：

MICROCHANNEL; OPTIMIZATION; PERFORMANCE; ALGORITHM; DESIGN;

D O I：

10.1016/j.ijheatmasstransfer.2017.05.106

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

Micro channel heat sinks with staggered pin fins are designed and studied in this paper. Three typical pin fins (rhombus, hydrofoil and sine) with symmetry geometries and low flow resistance were made a detailed comparison in the study. Simulations indicate that the heat sink with sine pin fins shows the best heat removal capacity and the lowest pressure drop when the coolant flow rate is 100 ml/min and the heating flux is 144 W/cm(2). Chip's hottest points are 357.90 K, 356.81 K and 354.91 K in the three cases and the pressure drops between the inlet and the outlet are 15793.50 Pa, 15242.21 Pa and 15196.04 Pa respectively. The same trend exists among the obtained experimental results and theoretical simulations. The research systematically studied the pin fins' influence to the heat sink by simulation and confirmed the conclusion by experiment. This method can be used in the following research about the heat sink. The study also found the best pin fins configuration of the three typical structures, and the structure will be helpful for the heat sinks design. (C) 2017 Published by Elsevier Ltd.

引用

页码：366 / 372

页数：7

共 50 条

[21] Cooling performance in a minichannel heat sink with different triangular pin-fins configurations
Zhao, Kai
Sun, Xiaoxia
Xia, Yuanqing
Li, Qiangqiang
Shen, Lili
Lin, Min
[J]. FRONTIERS IN ENERGY RESEARCH, 2023, 11
[22] Optimization of different pin-fins on heat transfer and pressure drop of a heat sink for antifreeze liquid case
Rostami, Sara
Nadooshan, Afshin Ahmadi
Raisi, Afrasiab
Bayareh, Morteza
[J]. JOURNAL OF THE TAIWAN INSTITUTE OF CHEMICAL ENGINEERS, 2023, 148
[23] Effect of different heating power on flow and convective heat transfer characteristics of triangle micro pin fins
Qiu, Delai
Guan, Ning
Zhang, Chengwu
Zhao, Xiaobao
Liu, Zhigang
[J]. Huagong Xuebao/CIESC Journal, 2015, 66 (06): : 2062 - 2069
[24] Experimental study on liquid flow and heat transfer in micro square pin fin heat sink
Liu, Minghou
Liu, Dong
Xu, Sheng
Chen, Yiliang
[J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2011, 54 (25-26) : 5602 - 5611
[25] Numerical hydrothermal evaluation of heat transfer in a multi-mini-channel heat sink: Effect of square pin fins
Hussein, Haider Ali
[J]. RESULTS IN ENGINEERING, 2023, 20
[26] Investigation of planted pin fins for heat transfer enhancement in plate fin heat sink
Yang, Yue-Tzu
Peng, Huan-Sen
[J]. MICROELECTRONICS RELIABILITY, 2009, 49 (02) : 163 - 169
[27] Microfabrication of Short Pin Fins on Heat Sink Surfaces to Augment Heat Transfer Performance
Wang, Congshun
Yu, Youmin
Simon, Terrence
Cui, Tianhong
[J]. 2012 13TH IEEE INTERSOCIETY CONFERENCE ON THERMAL AND THERMOMECHANICAL PHENOMENA IN ELECTRONIC SYSTEMS (ITHERM), 2012, : 944 - 950
[28] Investigation of heat transfer limits for flow boiling in expanding heat sinks having micro pin fins
Markal, Burak
Evcimen, Alperen
Atci, Fatih
Aydin, Orhan
[J]. INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2024, 156
[29] Study of heat transfer characteristics inside rectangular channel with different pin fins
[J]. Wang, F.-M., 1600, Science Press (35):
[30] Heat transfer characteristic for combined micro pin fins
Cui, Zhen-Zhen
Xia, Guo-Dong
Wu, Hong-Jie
Zhou, Ming-Zheng
Chai, Lei
Li, Jian
[J]. Beijing Gongye Daxue Xuebao/Journal of Beijing University of Technology, 2012, 38 (11): : 1698 - 1703

← 1 2 3 4 5 →