Experimental investigation of the two-phase discharge from a stratified region through two side branches oriented horizontally

被引:15
|
作者
Hassan, IG
Soliman, HM
Sims, GE
Kowalski, JE
机构
[1] UNIV MANITOBA,DEPT MECH & IND ENGN,WINNIPEG,MB R3T 5V6,CANADA
[2] ATOM ENERGY CANADA LTD RES,THERMALHYDRAUL BRANCH,PINAWA,MB R0E 1L0,CANADA
关键词
two-phase flow; experimental data; two side branches; horizontal orientation; correlation;
D O I
10.1016/0894-1777(96)00035-0
中图分类号
O414.1 [热力学];
学科分类号
摘要
Experimental data are presented for the mass flow rate and quality of two-phase (air-water) discharge from a stratified region through two side branches (6.35 mm I.D.) with their parallel centerlines located in a horizontal plane. These data correspond to different values of the interface level between the onset of gas entrainment and that of liquid entrainment for test section pressures of 316 and 517 kPa, test section-separator pressure difference 40-235 kPa, branch separating-distance-to-diameter ratio 1.5-8, and different hydraulic resistances of the lines connecting the test section to the separators. The influences of these independent variables on the deviation between the present results (of mass flow rate and quality) and those corresponding to a single discharge are presented and discussed. Normalized plots are presented showing that the present data of dual discharge and those of a single discharge can be collapsed for the whole test range when specific definitions are used for the dimensionless height of the interface and mass flow rate. Excellent agreement is demonstrated between single-discharge correlations and the present data using these dimensionless quantities.
引用
收藏
页码:117 / 128
页数:12
相关论文
共 50 条
  • [21] EXPERIMENTAL INVESTIGATION OF THE TWO-PHASE PHENOMENA IN A SMALL DISCHARGE INSTALLED ON A LARGE PIPE WITH STRATIFIED GAS-LIQUID FLOW
    Bowden, Robert
    Saleh, Wael F.
    Hassan, Ibrahim
    PROCEEDINGS OF THE ASME FLUIDS ENGINEERING DIVISION SUMMER CONFERENCE, VOL 1, PTS A-C, 2009, : 839 - 849
  • [22] A NEW CRITERION FOR THE ONSET OF LIQUID ENTRAINMEMT FROM A STRATIFIED TWO-PHASE REGION THROUGH A SMALL BRANCH
    Ahmed, Mahmoud
    Ali, Ahmed Hamza H.
    HT2009: PROCEEDINGS OF THE ASME SUMMER HEAT TRANSFER, VOL 3, 2009, : 505 - 510
  • [23] Experimental investigation of two-phase flow development through two-stage orifices
    Almalki, Naief
    Ahmed, Wael H.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 2024, 238 (15) : 7531 - 7543
  • [24] Experimental investigation of stratified two-phase flows in the hot leg of a PWR for CFD validation
    Vallee, Christophe
    Lucas, Dirk
    Tomiyama, Akio
    Murase, Michio
    ATW-INTERNATIONAL JOURNAL FOR NUCLEAR POWER, 2012, 57 (12): : 742 - +
  • [25] Investigation into stratified Co-and countercurrent two-phase flows
    Johnston, A.J.
    SPE Production Engineering, 1988, 3 (03): : 393 - 399
  • [26] Experimental CFD grade data for stratified two-phase flows
    Vallee, Christophe
    Lucas, Dirk
    Beyer, Matthias
    Pietruske, Heiko
    Schuetz, Peter
    Carl, Helmar
    NUCLEAR ENGINEERING AND DESIGN, 2010, 240 (09) : 2347 - 2356
  • [27] Experimental Investigation of Two-Phase Electrolysis Processes
    Zine, Derhoumi
    Philippe, Mandin
    Roustan, Herve
    INDUSTRIAL ELECTROCHEMISTRY AND ELECTROCHEMICAL ENGINEERING (GENERAL) - 221ST ECS MEETING, 2013, 45 (09): : 35 - 40
  • [28] Experimental investigation of two-phase gas-oil stratified flow wax deposition in pipeline
    Chi, Yuandao
    Sarica, Cem
    Daraboina, Nagu
    FUEL, 2019, 247 : 113 - 125
  • [29] Experimental investigation of the passage of fuel droplets through a spherical two-phase flame
    Thimothee, R.
    Chauveau, C.
    Halter, F.
    Goekalp, I.
    PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2017, 36 (02) : 2549 - 2557
  • [30] Experimental visualization of two-phase flow patterns and transition from stratified to slug flow
    Vaze, M. J.
    Banerjee, J.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 2011, 225 (C2) : 382 - 389