Bond strengths of nine current dentine adhesive systems to primary and permanent teeth

The aim of this study was to compare the shear bond strength (SBS) of nine dentine bonding systems (DBS) of different classes to human primary and permanent dentine. Flat dentine occlusal surfaces were produced on human molars (100 primary, 100 permanent) by wet grinding on a 800-grit SiC paper. Nine DBS were applied following the manufacturers' instructions: center dot One total etch multi-step system: Scotchbond Multipurpose Plus (3M/ESPE); center dot Four total etch one-bottle system: Prime &Bond 2.1 (Dentsply), One Step (Bisco), Scotchbond 1 (3M/ESPE), and OptibondSolo Plus (Kerr); center dot Three two-step self-etching primer systems: Clearfil Liner Bond 2 (Kuraray), Clearfil SE Bond (Kuraray), and Prime &Bond NT with NRC (Dentsply); center dot An 'all-in-one' self-etching system: Prompt L-Pop (3M/ESPE). Composite (Z100; 3M/ESPE) cylinders (2 mm diameter, 3 mm high) were polymerized on the treated dentine surfaces and the specimens were stored at 37 degrees C for 24 h prior to testing. Twenty experimental groups were produced and tested. Statistical analysis revealed both a substrate and a bonding system effect. Two adhesive systems (One Step, Prime &Bond NT) had significantly higher bond strengths on permanent than on primary dentine. There was an effect of dentine bonding system on the mode of fracture. Although eight of the 10 DBS tested exhibited higher median SBS values on permanent dentine than on primary dentine, the dependent pairwise comparison identified a significant difference only for two groups. The use of simplified bonding systems does not necessarily result in improved bond strength to primary or to permanent dentine.