Effect of Niobium Supersaturation in Austenite on the Static Recrystallization Behavior of Carbon Structural Steels

This work describes the effect of Nb supersaturation in austenite on the suppression of static recrystallization of austenite during an isothermal holding period following hot deformation. The investigation involved three carbon structural steels with varying Nb concentration at constant C (0.20 pct) and N (0.007 pct) levels. The isothermal double-hit deformation technique led to the determination of T-5 pct and T-95 pct (recrystallization-stop and full recrystallization temperatures, respectively) as a function of a true strain and interpass time. The results indicate that the T-5 pct increases with increasing Nb supersaturation in austenite at a rate of 40 degrees C per 0.006 pct Nb supersaturation for a true stain epsilon=0.40. At each respective T-5 (pct), all tested steels exhibited an Nb supersaturation ratio >= 7.5 in austenite. A high, localized strain-induced precipitation of Nb(CN) was observed at the austenite subgrain boundaries in the unrecrystallized microstructure. This translated into higher values for local precipitate-pinning forces (F-PIN), which were significantly higher than that predicted from equilibrium thermodynamics. The critical F-PIN for retardation of static recrystallization was found to be 1.6 MPa at the respective T-5 (pct) for each steel. The present study has contributed to advancing our knowledge of the interplay between Nb solute supersaturation and volume fraction of Nb(CN) precipitation in particular for carbon structural steels. It has also highlighted an opportunity to apply niobium, even an ultra-low addition (i.e., < 100 ppm) to commodity-grade structural steels to reduce overall alloying costs.