A vibration isolation system in low frequency excitation region using negative stiffness structure for vehicle seat

被引:371
|
作者
Le, Thanh Danh [2 ]
Ahn, Kyoung Kwan [1 ]
机构
[1] Univ Ulsan, Sch Mech & Automot Engn, Ulsan 680764, South Korea
[2] Univ Ulsan, Grad Sch Mech & Automot Engn, Ulsan 680764, South Korea
关键词
DESIGN;
D O I
10.1016/j.jsv.2011.07.039
中图分类号
O42 [声学];
学科分类号
070206 ; 082403 ;
摘要
This paper designs and fabricates a vibration isolation model for improving vibration isolation effectiveness of the vehicle seat under low excitation frequencies. The feature of the proposed system is to use two symmetric negative stiffness structures (NSS) in parallel to a positive stiffness structure. Here, theoretical analysis of the proposed system is clearly presented. Then, the design procedure is derived so that the resonance peak of frequency-response curve drifts to the left, the load support capacity of the system is maintained, the total size of the system is reduced for easy practical application and especially, the bending of the frequency-response curve is minimized. Next the dynamic equation of the proposed system is set up. Then, the harmonic balance (HB) method is employed to seek the characteristic of the motion transmissibility of the proposed system at the steady state for each of the excitation frequency. From this characteristic, the curves of the motion transmission are predicted according to the various values of the configurative parameters of the system. Then, the time responses to the sinusoidal, multi frequency and random excitations are also investigated by simulation and experiment. In addition, the isolation performance comparison between the system with NSS and system without NSS is realized. The simulation results reveal that the pro posed system has larger frequency region of isolation than that of the system with put NSS. The experimental results confirm also that with a random excitation mainly spreading from 0.1 to 10 Hz, the isolation performance of the system with NSS is greatly improved, where the RMS values of the mass displacement may be reduced to 67.2%, whereas the isolation performance of the system without NSS is bad. Besides, the stability of till steady-state response is also studied. Finally, some conclusions are given. (C) 2011 Elsevier Ltd. All rights reserved.
引用
下载
收藏
页码:6311 / 6335
页数:25
相关论文
共 50 条
  • [31] A High-Stiffness Sandwich Structure with a Tristable Core for Low-Frequency Vibration Isolation
    Hui Fang
    Ze Liu
    Ming Lei
    Liya Duan
    Journal of Vibration Engineering & Technologies, 2022, 10 : 1989 - 2003
  • [32] A High-Stiffness Sandwich Structure with a Tristable Core for Low-Frequency Vibration Isolation
    Fang, Hui
    Liu, Ze
    Lei, Ming
    Duan, Liya
    JOURNAL OF VIBRATION ENGINEERING & TECHNOLOGIES, 2022, 10 (05) : 1989 - 2003
  • [33] The vibration isolation characteristics of torsion bar spring with negative stiffness structure
    Yu, Chuanyun
    Fu, Qidi
    Zhang, Jianrun
    Zhang, Ning
    MECHANICAL SYSTEMS AND SIGNAL PROCESSING, 2022, 180
  • [34] Dynamic research on a low-frequency vibration isolation system of quasi-zero stiffness
    Jurevicius, M.
    Vekteris, V.
    Viselga, G.
    Turla, V
    Kilikevicius, A.
    Iljin, I.
    JOURNAL OF LOW FREQUENCY NOISE VIBRATION AND ACTIVE CONTROL, 2019, 38 (02) : 684 - 691
  • [35] COST-EFFECTIVE IMPLEMENTATION OF ACCELERATION FEEDBACK TO VIBRATION ISOLATION SYSTEM USING NEGATIVE STIFFNESS
    Shahadat, Mhia Md. Zaglul
    Mizuno, Takeshi
    Ishino, Yuji
    Takasaki, Masaya
    PROCEEDINGS OF THE ASME 5TH ANNUAL DYNAMIC SYSTEMS AND CONTROL DIVISION CONFERENCE AND JSME 11TH MOTION AND VIBRATION CONFERENCE, DSCC 2012, VOL 3, 2013, : 793 - 801
  • [36] A MODULAR-TYPE THREE-AXIS VIBRATION ISOLATION SYSTEM USING NEGATIVE STIFFNESS
    Hogue, Md. Emdadul
    Mizuno, Takeshi
    Ishino, Yuji
    Takasaki, Masaya
    PROCEEDINGS OF THE ASME DYNAMIC SYSTEMS AND CONTROL CONFERENCE 2010, VOL 2, 2010, : 577 - 582
  • [38] Analysis and design of a novel arrayed magnetic spring with high negative stiffness for low-frequency vibration isolation
    Wu, Jiulin
    Zeng, Lizhan
    Han, Bin
    Zhou, Yifan
    Luo, Xin
    Li, Xiaoqing
    Chen, Xuedong
    Jiang, Wei
    INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES, 2022, 216
  • [39] Low-frequency vibration isolation via new wide range zero-stiffness isolator with multiple negative stiffness mechanisms
    Wei, Chunyu
    JOURNAL OF THE BRAZILIAN SOCIETY OF MECHANICAL SCIENCES AND ENGINEERING, 2024, 46 (03)
  • [40] Low-frequency vibration isolation via new wide range zero-stiffness isolator with multiple negative stiffness mechanisms
    Chunyu Wei
    Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2024, 46