Experimental study of exhaust temperature variation in a homogeneous charge compression ignition engine

Homogeneous charge compression ignition (HCCI) engines have low nitrogen oxide and particulate matter engine-out emissions but have higher unburned hydrocarbon and carbon monoxide emissions than the conventional spark ignition (SI) and diesel engines do. Only for sufficiently high exhaust gas temperatures can an exhaust after-treatment be used; thus a low exhaust gas temperature in certain operating conditions can limit the operating range in HCCI engines. The influences of the engine conditions on the exhaust gas temperature in a single-cylinder experimental engine are investigated at 340 steady state operating points. The variation in the exhaust gas temperature is also studied under transient conditions and during mode switching between SI and HCCI combustion. For the conditions tested, a significant number of data have an exhaust gas temperature below 300 degrees C which is below the light-off temperature of typical catalytic converters on the market. Three different categories of engine variables are recognized and classified by how the exhaust temperature is affected by changing that variable. The first category is defined as the primary variables (e. g. the intake pressure and the fuel octane number) for which the location of ignition timing is the dominant factor in influencing the exhaust temperature. The other groups include compounding variables such as the engine speed and opposing variables such as the intake temperature, the coolant temperature, and the equivalence ratio. In addition, experimental results show that the exhaust temperature for HCCI engines is not strongly dependent on the engine load, unlike that for SI engines where the engine load is a main factor in determining the exhaust temperature.