Soot concentration and temperature measurements in co-annular, nonpremixed CH4/air laminar flames at pressures up to 4 MPa

被引:163
|
作者
Thomson, KA [1 ]
Gülder, ÖL
Weckman, EJ
Fraser, RA
Smallwood, GJ
Snelling, DR
机构
[1] Univ Waterloo, Dept Engn Mech, Waterloo, ON N2L 3G1, Canada
[2] Univ Toronto, Inst Aerosp Studies, N York, ON M3H 5T6, Canada
[3] Natl Res Council Canada, ICPET, Combust Res Lab, Ottawa, ON K1A 0R6, Canada
基金
加拿大自然科学与工程研究理事会;
关键词
soot formation; high pressure; laminar nonpremixed flame;
D O I
10.1016/j.combustflame.2004.11.012
中图分类号
O414.1 [热力学];
学科分类号
摘要
Laminar nonpremixed methane-air flames were studied over the pressure range of 0.5 to 4 MPa using a new high-pressure combustion chamber. Flame characterization showed very good flame stability over the range of pressures, with a flame tip rms flicker of less than 1% in flame height. At all pressures, soot was completely oxidized within the visible flame. Spectral soot emission (SSE) and line-of-sight attenuation (LOSA) measurements provided radially resolved measurements of soot volume fraction and soot temperature at pressures from 0.5 to 4.0 MPa. Such measurements provide an improved understanding of the influence of pressure on soot formation and have not been reported previously in laminar nonpremixed flames for pressures above 0.4 MPa. SSE and LOSA soot concentration values typically agree to within 30% and both methods exhibit similar trends in the spatial distribution of soot concentration. Maximum soot concentration depended on pressure according to a power law, where the exponent on pressure is about 2 for the range of pressures between 0.5 and 2.0 MPa, and about 1.2 for 2.0 to 4.0 MPa. Peak carbon conversion to soot also followed a power-law dependence on pressure, where the pressure exponent is unity for pressures between 0.5 and 2.0 MPa and 0.1 for 2.0 to 4.0 MPa. The pressure dependence of sooting propensity diminished at pressures above 2.0 MPa. Soot concentrations measured in this work, when transformed to line-integrated values, are consistent with the measurements of Flower and Bowman for pressures up to 1.0 MPa [Proc. Combust Inst. 21 (1986) 1115-1124] and Lee and Na for pressures up to 0.4 MPa [JSME Int. J. Ser. B 43 (2000) 550-555]. Soot temperature measurements indicate that the overall temperatures decrease with increasing pressure; however, the differences diminish with increasing height in the flame. Low down in the flame, temperatures are about 150 K lower at pressures of 4.0 MPa than those at 0.5 MPa. In the upper half of the flame the differences reduce to 50 K. Crown Copyright (c) 2004 Published by Elsevier Inc. on behalf of The Combustion Institute. All rights reserved.
引用
收藏
页码:222 / 232
页数:11
相关论文
共 50 条
  • [31] Viscosity of the CO2 + CH4 Binary Systems from 238 to 423 K at Pressures up to 80 MPa
    Chapoy, Antonin
    Owuna, Friday Junior
    Burgass, Rod
    Ahmadi, Pezhman
    Stringari, Paolo
    JOURNAL OF CHEMICAL AND ENGINEERING DATA, 2024, 69 (06): : 2152 - 2166
  • [32] Influence of preheating and burner geometry on modeling the attachment of laminar coflow CH4/air diffusion flames
    Xu, Huanhuan
    Liu, Fengshan
    Sun, Shaozeng
    Zhao, Yijun
    Meng, Shun
    Tang, Wenbo
    Feng, Dongdong
    Gu, MingYan
    COMBUSTION AND FLAME, 2018, 191 : 381 - 393
  • [33] The effect of hydrogen enrichment on the forced response of CH4/H2/Air laminar flames
    Lim, Zhengli
    Li, Jingxuan
    Morgans, Aimee S.
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2021, 46 (46) : 23943 - 23953
  • [34] Cellular structures of laminar lean premixed H2/CH4/air polyhedral flames
    Shi, Shuguo
    Breicher, Adrian
    Trabold, Johannes
    Hartl, Sandra
    Barlow, Robert S.
    Dreizler, Andreas
    Geyer, Dirk
    APPLICATIONS IN ENERGY AND COMBUSTION SCIENCE, 2023, 13
  • [35] Propagation of Laminar Premixed Flames of CH4/H2/Air Mixtures at Elevated Temperatures
    Shang R.-X.
    Yang Y.
    Li G.
    Dongbei Daxue Xuebao/Journal of Northeastern University, 2021, 42 (08): : 1173 - 1179
  • [36] Influence of NH4H2PO4 powder on the laminar burning velocity of premixed CH4/Air flames
    Hao, Jinyuan
    Du, Zhiming
    Zhang, Tianwei
    Li, Haoyang
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2022, 47 (90) : 38477 - 38493
  • [37] Experimental study of temperature and CH radical location in partially premixed CH4/air coflow flames
    Blevins, LG
    Renfro, MW
    Lyle, KH
    Laurendeau, NM
    Gore, JP
    COMBUSTION AND FLAME, 1999, 118 (04) : 684 - 696
  • [38] Onset of cellular flame instability in adiabatic CH4/O2/CO2 and CH4/air laminar premixed flames stabilized on a flat-flame burner
    Yu, J. F.
    Yu, R.
    Fan, X. Q.
    Christensen, M.
    Konnov, A. A.
    Bai, X. S.
    COMBUSTION AND FLAME, 2013, 160 (07) : 1276 - 1286
  • [39] Investigation of combustion enhancement by ozone additive in CH4/air flames using direct laminar burning velocity measurements and kinetic simulations
    Wang, Z. H.
    Yang, L.
    Li, B.
    Li, Z. S.
    Sun, Z. W.
    Alden, M.
    Cen, K. F.
    Konnov, A. A.
    COMBUSTION AND FLAME, 2012, 159 (01) : 120 - 129
  • [40] IMPACT OF EQUIVALENCE RATIO ON THE MACROSTRUCTURE OF PREMIXED SWIRLING CH4/AIR AND CH4/O2/CO2 FLAMES
    Watanabe, Hirotatsu
    Shanbhogue, Santosh J.
    Ghoniem, Ahmed F.
    ASME TURBO EXPO: TURBINE TECHNICAL CONFERENCE AND EXPOSITION, 2015, VOL 4B, 2015,