Influence of cutting tool stiffness on edge formability

For the evaluation of the forming behaviour of cut edges of AHSS the Hole Expansion Test (HET) standardized in the ISO 16630 is generally used. However, the observed Hole Expansion Ratio (HER) is prone to significant scatter. One reason for this scatter is the subjective observation of the through thickness crack by the machine operator. Additionally, the ISO is not very specific in its description of the test setup and material preparation, actually allowing great variations in the cutting process. Although the nominal cutting clearance is specified, a low stiffness of the punching machine or tool can cause a non-uniform clearance along the circumference. Additionally, an oblique position of the punch can cause an angled or eccentric sheared hole, resulting in additional crack initiation sites on the shear cut surface. FE simulations are used to investigate the stiffness effects of a C-frame press design. A comparative round robin analysis based on IS016630 was performed by cross-testing both cutting and hole expansion setups for a high strength hot rolled steel grade. Significant differences were registered in the HER values, whereby the cutting process was identified to have the largest influence on HER variation. The homogeneity of the burnished zone along the circumference was observed to give valuable information about the cut edge quality and subsequent level of HER values.