Influence of high power impulse magnetron sputtering plasma ionization on the microstructure of TiN thin films

被引:109
|
作者
Ehiasarian, A. P. [1 ]
Vetushka, A. [1 ]
Gonzalvo, Y. Aranda [2 ]
Safran, G. [3 ]
Szekely, L. [3 ]
Barna, P. B. [3 ]
机构
[1] Sheffield Hallam Univ, Nanotechnol Ctr PVD Res, Mat & Engn Inst, Howard St, Sheffield S1 1WB, S Yorkshire, England
[2] Hiden Analyt Ltd, Plasma & Surface Div, Warrington WA5 7UN, Cheshire, England
[3] Res Inst Tech Phys & Mat Sci, H-1525 Budapest, Hungary
基金
英国工程与自然科学研究理事会;
关键词
PREFERRED ORIENTATION; ENERGY-DISTRIBUTION; SURFACE-MORPHOLOGY; STRESS GENERATION; GROWTH; OXYGEN; LAYERS; DEPOSITION; DENSITIES; TIN(111);
D O I
10.1063/1.3579443
中图分类号
O59 [应用物理学];
学科分类号
摘要
HIPIMS (High Power Impulse Magnetron Sputtering) discharge is a new PVD technology for the deposition of high-quality thin films. The deposition flux contains a high degree of metal ionization and nitrogen dissociation. The microstructure of HIPIMS-deposited nitride films is denser compared to conventional sputter technologies. However, the mechanisms acting on the microstructure, texture and properties have not been discussed in detail so far. In this study, the growth of TIN by HIPIMS of Ti in mixed Ar and N-2 atmosphere has been investigated. Varying degrees of metal ionization and nitrogen dissociation were produced by increasing the peak discharge current (I-d) from 5 to 30 A. The average power was maintained constant by adjusting the frequency. Mass spectrometry measurements of the deposition flux revealed a high content of ionized film-forming species, such as Ti1+, Ti2+ and atomic nitrogen N1+. Ti1+ ions with energies up to 50 eV were detected during the pulse with reducing energy in the pulse-off times. Langmuir probe measurements showed that the peak plasma density during the pulse was 3 x 10(16) m(-3). Plasma density, and ion flux ratios of N1+ : N-2(1+) and Ti1+:Ti-0 increased linearly with peak current. The ratios exceeded 1 at 30 A. TIN films deposited by HIRIMS were analyzed by X-ray diffraction, and transmission electron microscopy. At high I-d, N1+:N-2(1+) > 1 and Ti1+:Ti-0 > 1 were produced; a strong 002 texture was present and column boundaries in the films were atomically tight. As I-d reduced and N1+: N-2(1+) and Ti1+:Ti-0 dropped below 1, the film texture switched to strong 111 with a dense structure. At very low I-d, porosity between columns developed. The effects of the significant activation of the deposition flux observed in the HIPIMS discharge on the film texture, microstructure, morphology and properties are discussed. (C) 2011 American Institute of Physics. [doi :10.1063/1.3579443]
引用
收藏
页数:15
相关论文
共 50 条
  • [1] Microstructure of ZnO thin films deposited by high power impulse magnetron sputtering
    Reed, A. N.
    Shamberger, P. J.
    Hu, J. J.
    Muratore, C.
    Bultman, J. E.
    Voevodin, A. A.
    [J]. THIN SOLID FILMS, 2015, 579 : 30 - 37
  • [2] Bioapplication of TiN thin films deposited using high power impulse magnetron sputtering
    Wu, Wan-Yu
    Chan, Man-Yee
    Hsu, Yu-Hsuan
    Chen, Guan-Zhen
    Liao, Shu-Chuan
    Lee, Cheng-Hung
    Lui, Ping-Wing
    [J]. SURFACE & COATINGS TECHNOLOGY, 2019, 362 : 167 - 175
  • [3] Microstructure control of CrNx films during high power impulse magnetron sputtering
    Greczynski, G.
    Jensen, J.
    Bohlmark, J.
    Hultman, L.
    [J]. SURFACE & COATINGS TECHNOLOGY, 2010, 205 (01): : 118 - 130
  • [4] Influence of Annealing Temperature on the Microstructure and Hardness of TiN Coatings Deposited by High-Power Impulse Magnetron Sputtering
    Anas Ghailane
    El Yazid Maadane
    Ayyoube Barchid
    Sabah Berchane
    Soukayna Badre-Eddine
    Hicham Larhlimi
    Christian B. Fischer
    Jones Alami
    Mohammed Makha
    [J]. Journal of Materials Engineering and Performance, 2022, 31 : 5593 - 5601
  • [5] Influence of Annealing Temperature on the Microstructure and Hardness of TiN Coatings Deposited by High-Power Impulse Magnetron Sputtering
    Ghailane, Anas
    Maadane, El Yazid
    Barchid, Ayyoube
    Berchane, Sabah
    Badre-Eddine, Soukayna
    Larhlimi, Hicham
    Fischer, Christian B.
    Alami, Jones
    Makha, Mohammed
    [J]. JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2022, 31 (07) : 5593 - 5601
  • [6] Morphology of TiN thin films grown on SiO2 by reactive high power impulse magnetron sputtering
    Magnus, F.
    Ingason, A. S.
    Sveinsson, O. B.
    Olafsson, S.
    Gudmundsson, J. T.
    [J]. THIN SOLID FILMS, 2011, 520 (05) : 1621 - 1624
  • [7] Effect of duty cycles on the deposition and characteristics of high power impulse magnetron sputtering deposited TiN thin films
    Chang, Chi-Lung
    Shih, Siao-Gu
    Chen, Pin-Hung
    Chen, Wei-Chih
    Ho, Chun-Ta
    Wu, Wan-Yu
    [J]. SURFACE & COATINGS TECHNOLOGY, 2014, 259 : 232 - 237
  • [8] Growth of HfN thin films by reactive high power impulse magnetron sputtering
    Thorsteinsson, D. O.
    Gudmundsson, J. T.
    [J]. AIP ADVANCES, 2018, 8 (03)
  • [10] Plasma flares in high power impulse magnetron sputtering
    Ni, Pavel A.
    Hornschuch, Christian
    Panjan, Matjaz
    Anders, Andre
    [J]. APPLIED PHYSICS LETTERS, 2012, 101 (22)