Position and Force Control of the CAPAMAN 2 bis Parallel Robot for Drilling Tasks

被引：5

作者：

Briones, J. Antonio ^{[1
]}

Castillo, Eduardo ^{[1
]}

Carbone, Giuseppe ^{[2
]}

Ceccarelli, Marco ^{[2
]}

机构：

[1] Inst Politecn Nacl, Unidad Queretaro, CICATA, Queretaro, Mexico

[2] Univ Cassino, DiMSAT, LARM, Cassino, Italy

来源：

CERMA: 2009 ELECTRONICS ROBOTICS AND AUTOMOTIVE MECHANICS CONFERENCE | 2009年

关键词：

Parallel robot; force control; robotic drilling; MANIPULATOR;

D O I：

10.1109/CERMA.2009.40

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

A proposal for position and force control in drilling tasks is presented on this work. Force feedback is done in a simple way with a load cell. Force control algorithm is implemented in 3 degrees of freedom (DOF) parallel robot, the CAPAMAN 2 Bis, developed by the Laboratory of Robotics and Mechatronics at the University of Cassino in Italy. A graphical interface and control software were developed in LabVIEW. The results of this work shows good behavior of the system in close loop with the proposed control algorithm. During a drilling test in wood, the behavior of the hybrid system serial-parallel is acceptable when penetration rates are low.

引用

页码：181 / +

页数：2

共 50 条

[21] Force-Position Hybrid Compensation Control for Path Deviation in Robot-Assisted Bone Drilling
Li, Shibo
Zhong, Xin
Yang, Yuanyuan
Qi, Xiaozhi
Hu, Ying
Yang, Xiaojun
[J]. SENSORS, 2023, 23 (16)
[22] The Use of Force Feedback to Control the Robot During Drilling
Chciuk, Marcin
Milecki, Andrzej
[J]. AUTOMATION 2019: PROGRESS IN AUTOMATION, ROBOTICS AND MEASUREMENT TECHNIQUES, 2020, 920 : 482 - 491
[23] AN APPROACH TO FORCE AND POSITION CONTROL OF ROBOT MANIPULATORS
CAI, L
GOLDENBERG, AA
[J]. PROCEEDINGS - 1989 IEEE INTERNATIONAL CONFERENCE ON ROBOTICS AND AUTOMATION, VOL 1-3, 1989, : 86 - 91
[24] Adaptive Force/Position Control of Robot Manipulators
Filaretov, Vladimir F.
Zuev, Alexandr V.
[J]. 2008 IEEE/ASME INTERNATIONAL CONFERENCE ON ADVANCED INTELLIGENT MECHATRONICS, VOLS 1-3, 2008, : 96 - 101
[25] CaPaMan2bis as Trunk module in CALUMA (CAssino Low-cost hUMAnoid robot)
Eduardo, Nava Rodriguez Nestor
Giuseppe, Carbone
Marco, Ceccarelli
[J]. 2006 IEEE CONFERENCE ON ROBOTICS, AUTOMATION AND MECHATRONICS, VOLS 1 AND 2, 2006, : 238 - +
[26] Adaptive Position/Force Control of Robot Manipulators with Force Estimation
Homayounzade, Mohamadreza
Keshmiri, Mehdi
[J]. 2014 SECOND RSI/ISM INTERNATIONAL CONFERENCE ON ROBOTICS AND MECHATRONICS (ICROM), 2014, : 736 - 741
[27] HYBRID POSITION-FORCE CONTROL OF CLIMBING PARALLEL ROBOT USING ELECTROHYDRAULIC SERVO ACTUATORS
Banfield, Ilka
Saltaren, Roque J.
Puglisi, Lisandro J.
Aracil Santonja, Rafael
[J]. PROCEEDINGS OF THE ASME INTERNATIONAL DESIGN ENGINEERING TECHNICAL CONFERENCES AND COMPUTERS AND INFORMATION IN ENGINEERING CONFERENCE - 2011, VOL 6, PTS A AND B, 2012, : 1203 - 1210
[28] Hybrid Position-Force Control of a Cable-Driven Parallel Robot with Experimental Evaluation
Kraus, W.
Miermeister, P.
Schmidt, V.
Pott, A.
[J]. MECHANICAL SCIENCES, 2015, 6 (02) : 119 - 125
[29] Parallel force/position controllers for robot manipulators with uncertain kinematics
Huang, Chun Qing
Shi, Song Jiao
Wang, Xing Gui
Chung, Wan Kyun
[J]. International Journal of Robotics and Automation, 2005, 20 (03): : 158 - 167
[30] Bilateral parallel force/position teleoperation control
Hashtrudi-Zaad, Keyvan
Salcudean, Septimiu E.
[J]. American Society of Mechanical Engineers, Dynamic Systems and Control Division (Publication) DSC, 1999, 67 : 351 - 358

← 1 2 3 4 5 →